User manual AUTOTECH 10.202.3011K 3021K

[. . . ] Installation Instructions Part Number: 10. 202. 3011K 2. 0L Golf/ Jetta 1993-1995 10. 202. 3021K VR6 Golf/ Jetta 1994-95 Description: Mk3 2. 0L VR6 OBDI CAI Instructions Warning: Before starting the installation of you new Autotech Cold Air Intake System there are a few things that you should be aware of and a couple of basic tools that will help in the installation process. 1) be aware that you will be removing some parts and not reusing them due to the fact that they will be in the way of the new intake system. [. . . ] Remove small vacuum line from middle of the vacuum "T" under the mass-air meter, and install supplied vacuum hose (the thinnest size) using our clamp. Remove the carbon canister inlet hose and install supplied hose union and vacuum hose to the end of the original hose using supplied clamps. Remove the other hose from the top of the carbon canister and install supplied hose union and vacuum hose to the end of the original hose using supplied clamps. Remove the carbon canister (slide up in slots) 11. Mount the carbon canister in the driver's side of the car in the same manner and location it was installed on the passenger side from the factory. Install the complete inlet tube into the car. Drill 1/8" hole through the hole in the mounting tab of the inlet tube. Install the Autotech silicone hose and clamps to the other end of the inlet tube. Re-install the Autotech CAI assembly into the car. (be sure not to over-tighten the clamps) 17. [. . . ] Attach the vacuum hoses to the lower radiator support using the supplied zip-ties. Securely attach all vacuum hoses in the engine compartment so they won't be damaged by engine vibration. [. . . ]