User manual AUTOTECH 10.611.208K-212K

[. . . ] A U T O T E C H Installation Instructions Part Number: Description: Procedure: 10. 611. 208K THRU 10. 698. 212K SPORTTUNED STAINLESS STEEL BRAIDED BRAKE LINES 1. Jack up the car and support it on jack stands. [. . . ] The bolt can be pressed out of the washers and banjo fitting in a vise using a 15mm or larger 1/2 inch drive socket for a receiver, as shown below. We supply new copper washers to replace the originals that will be destroyed during this process. Copper washer Copper washer bolt Push bolt through by closing vise 15mm socket original banjo end bench vise or C-clamp 4. Using a new M10 copper washer on each side of the banjo fitting, attach the Autotech brake line to the caliper. Make sure to align the notch on the end of the banjo fitting with the locating pin in the caliper if your car has one. Make sure that the brake line does not rub against any other metal objects as the braid will gradually grind through whatever it is touching. 32240-E Paseo Adelanto, San Juan Capistrano, CA 92675 Phone 949. 240. 4000 Fax 949. 240. 0450 1 5. Insert the female end of the Autotech brake line through the bracket on the inner fender. Place the spring clip over the hose end, and thread the spinning male hard line fitting into the hose end. Using a wrench on both fittings, tighten to 1 ft. For the rear of the vehicle, it may be necessary to loosen the bolts mounting the rear axle beam and lower it away from the body (with a floor jack as support) in order to gain access to the "middle" brake hoses. For the middle hoses, all cars will re-use the original retaining clips, even if the new Autotech hoses use ends that look a little different than your original ones. Refer to your repair manual for the correct tightening torques on the axle beam bolts if you removed them. This new end design replaces the grooved female ends found on A3 cars. The rear-most hoses for cars with disc brakes install using original retaining clips. Start by threading the male end into the caliper and tightening to 1 ft. Then insert the female 1 end through the factory bracket, and thread the male hard line into the hose, being sure to install the retaining clip in between. [. . . ] When servicing brakes, do not allow calipers to hang from hoses!Use a cord, wire, or other secure method of hanging the caliper so that brake hose is not loaded. 2 [. . . ]