User manual AVANTI 1151WT-1

[. . . ] We have provided many important safety messages in this manual for your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the wo rds " DANGER", "WARNING" or "CAUTION". Danger means that failure to heed this safety statement may result in severe personal injury or death. Warning means that failure to heed this safety statement may result in extensive product damage, serious personal injury, or death. Caution means that failure to heed this safety statement may result in minor or moderate personal injury, property or equipment damage. [. . . ] The power cord of this unit is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This unit requires a standard 115/120 Volt AC ~/60Hz electrical outlet with three-prong ground . Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. The cord should be secured behind the unit and not left exposed or dangling to prevent accidental injury. If you attempt to restart before this time delay, the unit will not start. Using Your Ice Cube Tray (Only on models RM1700W / 1701B / 1702PS) ?Recommended thermostat setting for i ce making is position "6". Fill the ice cube tray (two thirds of it) with cold water or with any liquid suitable for freezing and place the tray on the bottom of the chiller compartment to freeze properly. In addition, never use a sharp or metallic instrument to remove frost as it may damage the cooling system and will void the warranty. We recommend using a plastic scraper. 11 ?Turn the temperature control to "OFF", unplug the unit and remove the food, shelf, and tray. Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. Wash the shelf and tray with a mild detergent solution. The outside of the unit should be cleaned with mild detergent and warm water. Wring excess water out of the sponge or cloth before cleaning the area of the controls, or any electrical parts. Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. CAUTION: Failure to unplug the unit could result in electrical shock or personal injury. ?Power Failure Most power failures are corrected within a few hours and should not affect the temperature of your unit if you minimize the number of times the door is opened. [. . . ] COMO AJUSTAR EL CONTROL DE TEMPERATURA Su unidad tiene un solo control para regular la temperatura, este control se encuentra localizado en la parte superior derecha del compartimiento. Al conectar y encender su unidad, asegúrese de rotar el control de temperatura hacia la posición de "6". Este control de temperatura puede variar desde "OFF" hasta la posición "6", después de haberse mantenido en la posición "6" por 24 o 48 horas aproximadamente, regrese el control de temperatura para ajustarlo a la posición que más se ajuste a sus necesidades, por ejemplo la posición "4" sería apropiada para usar su unidad en su hogar u oficinas. Para apagar su unidad, simplemente rote el control de temperatura hacia la posición de "OFF". [. . . ]