User manual AVANTI WDE98PS INSTRUCTION MANUAL

[. . . ] INSTRUCTION MANUAL Model Numbers/Número de Modelos: WDE98PS ELECTRONIC WATER DISPENSER ENFRIADOR DE AGUA FRIA Y CALIENTE ELECTRONICO BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. La secc ión en español empieza en la página 13. Avanti has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. Avanti Products P. O. Box 520604 - Miami, Florida 33152 www. avantiproducts. com Registration Information Thank you for purchasing this fine Avanti product. Please fill out this card and return it within 100 days of purchase and receive these important benefits: ? [. . . ] Using the HOT (+) or COLD (-) buttons you can adjust the "minutes" display. Wait for the display to stop blinking (approximately 10 seconds). Press the HOT button once to turn on the hot function. Press the SET button (3 times) the amber numbers appear on the left side of the display panel. Using the HOT (+) or COLD (-) buttons you can adjust the temperature to the desired setting. Wait for the display to stop blinking (approximately 10 seconds). COLD Function Press the COLD button once to turn on the cold function. Press the SET button (4 times) the blue numbers appear on the right side of the display panel. Using the HOT (+) or COLD (-) buttons you can adjust the temperature to the desired setting. Wait for the display to stop blinking (approximately 10 seconds). NOTE: Once the selected temperature is reached, the readout will display it. Since it may take a while to reach the selected temperature, you will be able to see in numerical sequence (plus or minus) other temperature readings. COLD Water temperature range is from 41ºF-59F (5ºC-15ºC). The factory-preset setting is 6ºC/45ºF. HOT Water temperature range is from 122ºF-198ºF (50ºC-92ºC). Try the suggestions outlined below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM Water dispenser does not operate. The circuit breaker tripped or a blown fuse. Check to be sure the cold feature is selected. The water dispenser does not have the correct clearances. Check to be sure the hot feature is selected. The room temperature is hotter than normal. The temperature control is not set correctly. The water dispenser does not have the correct clearances. [. . . ] PRESIONE EL BOTON SET 4 VECES HASTA QUE LOS NUMEROS AZULES APAREZCAN EN EL LADO DERECHO DE LA PANTALLA. USANDO LOS BOTONES HOT (+) O COLD (-) PODRA AJUSTAR LA TEMPERATURA AL NIVEL DESEADO. ADVERTENCIA: UNA VEZ QUE PRESIONE EL BOTON SET, TIENE 10 SEGUNDOS PARA AJUSTAR LA HORA O LA TEMPERATURA, DE LO CONTRARIO LA PANTALLA SE BORRARA. LA TEMPERATURA PARA EL AGUA FRIA (COLD) VA DESDE 39º F ­ 50º F (4º C ­10º C). [. . . ]