User manual AVIOM AN-16SBR

[. . . ] The System Bridge is also compatible with Aviom's Pro16 Monitor Mixing System products, which include the A-16II and A-16R Personal Mixers. Up to four separate monitor systems can be transmitted over a single Cat-5e cable by using a System Bridge. A-Net output data streams from a System Bridge can be connected to Pro16 A-Net distributor products such as the A-16D and A-16D Pro to create digital splits as needed. [. . . ] The Cat-5e cable runs between the A-Net devices connected with System Bridges must not exceed the maximum cable length of 500 feet (150 meters). Aviom AN-16SBR System Bridge User Guide Using the System Bridge When creating an audio network with Aviom Pro16 products, for example the AN-16/i and AN-16/o, up to four of each module can be used with one System Bridge pair. Pro16 products can be combined as needed to create a flexible and reconfigurable system suited to a wide variety of audio applications. The A-Net ports labeled A, B, C, and D on the AN-16SBR are directly related. Pro16 signals plugged into port A of the AN-16SBR on one side of the network appear at port A on the AN-16SBR on the other side. For example, if an AN-16/i Input Module is used on one side of the network, a corresponding AN-16/o Output Module will be used on the other side; analog in feeds analog out. The A-Net Out on the Input Module is connected to the AN-16SBR Port A at one end of the network. The Output Module's A-Net In is connected to Port A at the other side of the network. A-Net Out AN-16/i A-Net In AN-16/o A B C D AN-16SBR Bridge A B C D AN-16SBR A complete system, in this case a 64 x 0 configuration, would look like this: A-Net Out AN-16/i AN-16/i AN-16/i AN-16/i A B C D AN-16SBR Bridge A B C D AN-16SBR A-Net In AN-16/o AN-16/o AN-16/o AN-16/o Configurations As seen in the examples above, any combination of AN-16/i and AN-16/o modules can be used to create a network. To create other configurations, simply swap the position of any pair of modules. For example, to create a network with 48 channels sending and 16 channels returning (48 x 16), switch the positions of the devices attached to port D of the AN-16SBR. Any compatible Pro16 input module (such as the AN-16/i-M, Y1 card for Yamaha, or D-16c for DiGiCo) can be substituted in the examples above. Remember that an A-Net output connected to a particular port on one side of the network will always connect to an A-Net input of a device connected to the same-lettered port on the other side of the network. Aviom, Inc. warrants this product against defects in materials and workmanship for a period of one year from the date of the original retail purchase. This warranty does not apply if the equipment has been damaged due to misuse, abuse, accident, or problems with electrical power. The warranty also does not apply if the product has been modified in any way, or if the product serial number has been damaged, modified, or removed. If a defect is discovered, first write or call Aviom, Inc. to obtain a Return Authorization number. No service will be performed on any product returned without prior authorization. will, at its option, repair or replace the product at no charge to you. [. . . ] DOES NOT ACCEPT LIABILITY BEYOND THE REMEDIES SET FORTH IN THIS LIMITED WARRANTY DOCUMENT. AVIOM, INC. 'S LIABILITY IS LIMITED TO THE REPAIR OR REPLACEMENT, AT OUR OPTION, OF ANY DEFECTIVE PRODUCT, AND SHALL IN NO EVENT INCLUDE INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND. SOME STATES DO NOT ALLOW EXCLUSIONS OR LIMITATION OF IMPLIED WARRANTIES OR LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU. [. . . ]