User manual AVISION IS 15

[. . . ] Sheet-fed type Photo Scanner User Manual Regulatory model: FS-0913B Trademarks Microsoft is a U. S. registered trademark of Microsoft Corporation. Windows and MS-DOS are trademarks of Microsoft Corporation. IBM, IBM PC are registered trademarks of International Business Machines Corp. [. . . ] When the scan is completed, the scanner will automatically create a folder titled "Photo1" on your memory card or flash card, which will hold the first 9999 scans. Then "Photo2" folder will be created for the next 9999 scans, and so on. (Each scanned image is given a file name with the prefix img followed by a 4- digit sequential number in the order the images are stored. For example, img0001. jpg, img0002. jpg, etc. ) Note: · Do not remove the memory card or disconnect the power supply while the indicators are blinking. · This scanner only supports output images in JPEG (. jpg) format. · If the memory card is near full (lower than 1MB), the indicator light blinks. Use another card or delete some files on it if necessary. · Insert only one original at a time, and insert the next original only when the previous one is done and the blinking has stopped, otherwise the scanner may malfunction. · Remove the things remained on the photo, such as staples, paper clips, and paper sticky notes before feeding it into the scanner due to possible damage to the scanner. 3-3 3. 3 Using Plastic sheaths Always use the clear plastic sheath (included) when scanning photos to ensure the best scanning results. The sheath helps eliminate the possibility of defocusing due to the uneven surface of curled photos. Curled photo 1. Insert the photo into the plastic sheath as shown below. 2. Insert the plastic sheath, flat and level, into the scanner's feeding slot, folded side first, image facing up. Note: · Keeping the original flat and level when feeding prevents possible jamming. · Keep originals free from finger prints, oil, dirt, and dust for optimum scanned image quality. · Remove photos from the plastic sheath after scanning to prevent the sheath from sticking to the photos over time. · If the plastic sheaths are not in use, store them in a safe place and keep them protected from accumulating dust. 3-4 3. 4 Scan dark or night pictures When you need to scan dark or night pictures, be sure to insert your photo into the white plastic sheath to avoid an incomplete scanned image. However, using the white plastic sheath will disable the auto crop (automatic crop your image according to your photo size) and deskew (auto straighten) functions. This means though you have completed scanning your photo, your image may look slightly skew if you have not placed the photo straight in the scanner. . The scanned image using white plastic sheath 3-5 3. 5 Power off the scanner After all originals are scanned, disconnect the supplied power adapter from the scanner. Now the scanner has been safely powered off. When the scanner connects successfully with a computer, a Removable Disk (F) (F represents the removable drive letter) will be shown in Windows Explorer. If a memory card or flash disk is inserted to the scanner, the Removable Disk will be replaced with the name of the memory card or flash disk. After your scan, a folder titled PHOTO1 is added to the memory card or flash disk and the scanned image will be saved in JPEG file format. Each scanned image is given a file name with the prefix scan followed by a 4- digit sequential number in the order the images are stored. [. . . ] Answer: Check the following: Are there scratches on the original, or is the original clean?Remove any stains or dust from the original before scanning. Has the scanner been used for a long period of time without cleaning and calibration?Follow the instructions for "Cleaning the Scanner" and "Calibrating the Scanner", and then try again. Question: The original gets stuck halfway in the feeding slot. [. . . ]