User manual AVM P2

[. . . ] Setting of cartridge type Use the mini-switches (3, 6) on the rear panel to set the P2 to MM or MC depending on the cartridge type. All switches must be in the same position. [. . . ] Use only high quality polypropylene capacitors. MC: First find out the recommended resistive load (see manual of cartridge). Then see table below for additional resistance values to be soldered into the RCA plugs connected to the P2's load terminals. Use only high quality metal film resistors. Total load 1000 500 300 150 100 resistor none 1000 429 176 111 Total load 75 50 30 20 10 resistor 81 53 31 20 10 Operating instructions Phono pre-preamplifier /equalizer P2 Technical data P2 Sensitivity Input impedance S/N ratio Frequency response Power supply Dimensions Weight MM 1, 5 mV 47 kOhms/47 pF 79 dB /85 dB(A) MC 180µV 1 kOhm / 1 nF 74 dB / 80 dB(A) 30 Hz ­ 20 kHz +/- 0, 3 dB (RIAA courve) 230V / 50 Hz / 3VA (AC adaptor) 145 x 48 x 70 mm 0, 3 Kgs AVM Next Generation GmbH, Daimlerstraße 8, 76316 Malsch Issued: 12/2007. Changes reserved without notice Dear customer, thank You for purchasing this AVM product. You own now a versatile, excellent sounding hi-fi component. Before enjoying music, please read this manual carefully. After that You will know how to use your new AVM component in the optimal way. Sincerely Yours Your AVM-Team Rear Panel Declaration of conformity (for EC only) We herewith confirm, that the unit to which this manual belongs fulfills the EC rules necessary to obtain the sign 1 power supply connector 2 audio output 3 MM / MC-selector right channel 4 audio input from cartridge 5 load terminals 6 MM / MC-selector left channel 7 ground connector Power supply insert the supply plug of the AC adapter into the power supply connector (1). [. . . ] Connect the grounding cable of the turntable or tone arm to the ground connector (7) of the P2 AVM Next Generation Audio Technologies GmbH, Daimlerstraße 8, D-76316 Malsch Website: www. avm-audio. com, E-mail: info@avm-audio. com Amplifier: Connect the audio output (2) of the P2 to any high level input of Your amplifier. Do NOT use the phono input because the P2 already amplifies and equalizes the cartridge signal to a high level signal. [. . . ]