User manual AZDEN PCS-6000H

[. . . ] Now you are the owner of the most advanced state--of the--art VHF FM transceiver available today. Please read this manual carefully before attempting to operate your PCS--6000 transceiver. This will ensure that you obtain the maximum operating convenience and versatility. Unpack your PCS--6000 carefully and make sure that it is supplied with the standard accessories listed at page 14. [. . . ] To disable the reverse mode operation, push the RF:V key again and the RFV indicator is turned off to indicate that the reverse mode is disabled. 7. How to operate Tone: When `F' indicator is lit (after the `F' switch is pushed) pressing the TONE key will activate tone encoder and the `TONE' indicated on the display. Repeating the same procedure will turn the TONE off and the TONE indicator comes off. Note : 1 ) The tone key operation is disabled when tone code( s ) are not programmed in the computer. 2) Refer to `How To Program' for tone code programming. 3) The tone function is automatically activated when the tone code is pre-- programmed in memory channel. --8-- After a round of procedures for storing the receiving and transmitting frequencies and tone code, the Memory Address Indicator flickers showing the next channel. By repeating the same procedures as above, you can store r eceive frequencies, receive tones, as well as transmit frequencies and transmit tones in the memory bank AD through A9 and memory bank BO through B 9 for a total of 20 channels. After the tone code is entered in the B9 memory channel, the unit is in the Up/Down mode for setting tone, shift width, delay scan and frequency stop other than in the memory channels. The receiving tone code will be indicated by entering tone code number. Press the M MODE key and the TONE indicator will flicker. Select any desired tone code by the UP/DOWN key and push the M MODE key to complete the entry. Note: This procedure is not required unless the unit is provided with the tone squelch unit. By the transmit tone code number, the transmit tone code will be indicated. Pushing the M MODE key to let the indicator flicker. Then, select tone code desired by the use of the UP/DOWN key and push the M MODE key again to complete the entry. Scanning Mode: The "3 00" appears on the display, indicating that the unit in the Delay Scan mode. Pushing the N MODE key and the indicator will flicker. Select either "3" or `6" by the UP/DOWN key and press again the M MODE key to decide 3 seconds or 6 seconds HOLD mode. Frequency Step: The display is indicated as "4 . 5Mhz" to denote that the up/down frequency step is set to 5kHz. Pressing the N MODE key will indicator flicker. [. . . ] Thus quick access to the channel, which may be used frequently, can be attained. -- 14 -- ACCESSORIES LIST 1. version. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PCM--463* ( European version} (Asian `` ) 2. Microphone Hanger. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]