User manual B&K AV7.1 SYSTEM CONTROLLER

[. . . ] B&K AV7. 1 Preprogrammed & Learning Remote Control Operating Manual P/N 12702 Rev 0006 Table Of Contents Page Introduction Battery Installation A. How To Open and Close Battery Compartment Cover B. Low Battery Message 2 3 3 Using Your Remote Control A. Function Table Reference Function Tables B. [. . . ] Return to the normal operating mode, by pressing the Device and the SEL / PLAY buttons simultaneously. 5. The learned functions on the selected buttons have now been erased. The default preprogrammed functions for these buttons will now operate on the remote control. 15 Using Your Remote Erasing All Functions in One Device Mode 1. Press the Device button for the mode to be erased. Press and hold the Device and SEL / PLAY buttons simultaneously, for approximately three seconds, until the LCD shows LEARN. Press and hold the Device and LIGHT buttons simultaneously, for approximately five seconds and then release the buttons. The LCD will flash ERASE and then alternately CLEAR and the Device Mode. Note: This procedure takes about two minutes to complete. When the LCD on the remote control returns to the Device Mode, all the learned functions have in the selected Device Mode have been erased. All the buttons in that Device Mode will now operate with the default preprogrammed functions in that mode. Erasing All Buttons in All Device Modes 1. Press and hold the TV Device Button and the LIGHT button simultaneously, for approximately ten seconds. The LCD will flash ERASE ten times, flash CLEAR and then return to the TV mode. When the LCD on the remote control returns to TV, all the learned functions in all eight Device Modes have been erased. All buttons in all Device Modes will now operate with the default preprogrammed functions in their respective modes. 16 Using Your Remote D. Operation After you have programmed the remote control for your equipment, use the following procedures to operate your home entertainment system: 1. Press the Device Button that you wish to operate: i. e. to operate a TV, press the TV device button: to operate a VCR, press the V1 Device Button, etc. Aim the remote control at the device and press the POWER button to turn the device on. Press the buttons that send out the commands you desire. 2. 3. Note: Some audio and video devices have separate buttons for POWER ON and POWER OFF. To operate these devices on the remote, press the corresponding DEVICE button to turn the equipment ON and press the POWER button to turn the equipment OFF. Please try all the functions of this remote control with your equipment. The most common functions are labeled on the remote. However, some of the secondary functions might be stored under a button that has a different name from the one on your original remote control. Please refer to the Function Tables on pages 5 ­ 7 for details. Device Buttons Pressing a Device button at the top of the remote performs the following functions: 1. [. . . ] When your device turns off, proceed to Step 6. Press the Device Button that was selected in Step 2 to store the Set-Up Code number. PASS will flash in the LCD to confirm the programming. The second device can now be operated by pressing the assigned Device Button and using the buttons within this mode. Example: To get a second TV to work in the V1 Device Button, when you already have a TV programmed into the TV Device Button. [. . . ]