User manual B&K CT-1

[. . . ] B & K Components, Ltd. CT-1 User Manual IR Routing System Integrator For use with CT Multi-Zone Receivers and Home Theater Systems 13475 0705D USER MANUAL - CT-1 © 2005 B & K Components Ltd. All rights reserved. The information in this manual is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from B & K Components, Ltd. SHALL NOT BE LIABLE FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE IN THIS MANUAL. [. . . ] CT 3 Flasher IN - Nine 1/8" mini connectors. One CT Receiver is connected by nine 1/8" mini jack interconnects. Each interconnect should be connected corresponding with the IR output on the CT Receiver back panel. These inputs are also used when chaining multiple CT-1's. CT 3 / Chain Out - One 1/8" mono mini connector. To be used with an IR emitter for control of a CT Reciever. This output is a sum of IR Data from CT-1, CT-2, Home Theater and Chain IN. This output is used when chaining CT-1s to send IR to the previous CT-1 in the chain. CT 2 Flasher IN - Nine 1/8" mini connectors. One CT Receiver is connected by nine 1/8" mini jack interconnects. Each interconnect should be connected corresponding with the IR output on the CT Receiver back panel. IR OUT 1 connects to Flasher IN 1, etc. 4 CT-1 Back Panel 7. CT 2 OUT - One 1/8" mono mini connector. To be used with an IR emitter for control of a CT Receiver. This output is a sum of IR Data from CT-1, CT-3, Home Theater and Chain IN. Home Theater Routing -On/Off DIP switches determine which of the nine IR FLASHER outputs will emit IR to a shared source from the HOME THEATER IR inputs. These DIP switches will allow IR Data from the Home Theater to control certain shared sources. HOME THEATER IN / OUT - Two 1/8" mono mini connectors. IN - IR input from a Home Theater (same as Home Theater Sensor IR-IN). OUT - IR output to a Home Theater product. This output is a sum of all IR Data coming into the CT-1 (Global Output). This output can also be used as a global system IR output. [. . . ] Set the DIP switche(s) to pass IR an un-used IR flasher output. Otherwise the theater receiver/processor Control Outputs can be set to pass IR. You may not need both forms of communication connected, only connect what you need. IR = 1/8" mono mini jack RS-232 = CAT5 straight through cable The Home Theater sensor plug (three position phoenix) can be used either for a Keypad (CK1. 2) or for an IR Data souce located in the theater room. [. . . ]