User manual B&K CT300.3

[. . . ] B & K Components, Ltd. User Manual CT600. 1 CT600. 3 CT300. 3 Multi-Zone Audio/Video Receivers 14067 121206 CT Receiver and Benefits COMPLETE USER MANUAL - CT RECEIVER © 2006 B & K Components, Ltd. All rights reserved. The information in this manual is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from B & K Components, Ltd. SHALL NOT BE LIABLE FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE IN THIS MANUAL. [. . . ] A split mono zone may utilize 3 different code-sets if variable volume control is desired; one code-set for the left side, one code-set for the right side and one code-set to control both sides together. Check the desired side of the zone corresponding to the Code-Set it will be controlled by. Regardless of how this is set, this split mono zone will always listen to the same input. When the input is changed for one side of the mono zone, the input will be changed for the other side as well. Bass, treble and EQ settings will be shared between the split mono zone at the same level. In the example above, the Master Suite is served using three groups. Each adjoining room may be adjusted without affecting the others by using keypads or remote set to Code-Sets 018 and 019. However, when a keypad uses Code-Set 014, both rooms within the Master Suite will be adjusted together. The absolute volume in Code-Set 014 is selected in order to sync the volumes at the same level when the suite is controlled as one zone. S IMPLY B ETTER! B&K Sub-Zoning 41 Splitting a Zone To Mono Once a zone has been split into mono it has the ability to have a discrete IR Code-Set assigned to it and therefore the user is given the capability to control volume, mute, and power in the split zone independently. For more information on Code-Sets, see Page 38. The Installation diagram of a mono zone split for control is illustrated below. The split mono zone will still share the same source, bass, treble and EQ settings. In this example, the master bath and master bedroom split a zone into two mono zones. Each mono zone must listen to the same source, but volume and on/off states are independent via the two keypads. The keypads are daisy chained to the same zone control terminal. The CT Receiver must be setup to respond to the discrete Code-Set for each mono zone. Furthermore, the corresponding Code-Set should be programmed onto the keypad. Thus, the Master Bath keypad will affect only the Master Bath and the Master Bed keypad will affect only the Master Bed. When keypads are slaved off of one another, programming should be done in series order starting with the master keypad, then slave 1, etc. Both keypads may also have the ability to control both zones together as a suite. The alternative to mono split zones is to assign the the master bed and master bath to separate independent zones. S IMPLY B ETTER! B&K 42 Input Settings - Tab 3 3 1 2 1. Shared Source Input Names: The programmer may customize the input name to a user friendly name (up to a 5 letter name). Inputs 1 through 9 may be selected in every zone, thus they are shared inputs. This is the same name that will display on the keypad when zone status is recalled by pressing the backlight button on the CK1. 2 or CK1. 1 Keypad. 2. [. . . ] All B & K products sold through authorized dealers are covered by a 5 year, parts and labor factory warranty. ADDITIONAL B & K PRODUCTS CK1. 2 and CK1. 1 Keypad Control ­ Complex control veiled in Simple Elegance is B & K's solution to whole house automation. Programmable LCD screen capable of operating 20 different devices. Over 1000 IR codes available to fully automate and control audio/video accessories. Also, features 2-way feedback & intelligent input synchronization. [. . . ]