User manual B&W AWM 65 INSTALLATION

[. . . ] AW M 6 5 / 7 0 SPEAKER INSTALLATIO N NOTES AWM65/70 Speaker Installation Notes THESE NOTES MUST BE READ IN CONJUCTION WITH THE CASA INSTALLATION MANUAL. Fitting (Figure 1) Note: The assembly should be installed with the tweeter at the bottom ­ The speaker is tuned to work best in this orientation. [. . . ] When you are satisfied that the installation is performing correctly, lay a scrim into each grille and push all the grilles into the wall frames. Avoid touching the drive units, especially the tweeter, as damage may result. Unpacking Check the contents: · 2 x Baffle with drive units and on-board amplifiers 2 x Speaker grille scrims 8 x Machine screws · · Damping the wall cavity A foam pad is supplied to damp the area behind the drive units. In addition, loosely fill the whole section of the wall cavity with wadding. In order to ensure proper cooling of the loudspeaker allow a 3 inch air gap above the frame's top edge. Fibreglass and mineral wool matting supplied for heat insulation are suitable, but not closed cell foam or expanded polystyrene. Check that there is no debris that may fall into the speaker (especially in ceiling mount situations). IMPORTANT: YOU SHOULD CHECK THAT THE MATERIALS YOU USE MEET THE LOCAL FIRE AND BUILDING REGULATIONS. Customising If the grille is to be re-finished remove the Infra-Red "eye" by removing the rubber retaining ring ­ refit before fitting the grille. Do not paint the baffle or drive unit area. [. . . ] B&W Loudspeakers Ltd, Meadow Road, Worthing, BN11 2RX, England Tel: +44 (0) 1903 524801 Fax: +44 (0) 1903 524725 B&W Loudspeakers of America, 54 Concord Street, North Reading, MA 01864-2699, USA Tel: (1978) 664 2870 Fax: (1978) 664 4109 http://www. bwspeakers. com [. . . ]