User manual B&W CC6 S2

[. . . ] (figures 3 & 4) All connections should be made with the equipment switched off. There are 2 pairs of terminals at the back of the speaker which permit bi-wiring if desired. On delivery, the separate pairs are connected together with high-quality links for use with a single 2-core cable. [. . . ] Otherwise position it directly above or below the screen, whichever is closest to ear level. Align the front of the speaker approximately level with the screen. fix the 4 self-adhesive pads to the base of the speaker. They give a degree of vibration isolation, especially useful if placing the speaker directly on top of a fairly flimsy television. The flat area on top of the television may be smaller than the base of the speaker, so position the feet accordingly. Before fine tuning, double check that all the connections in the installation are correct and secure. For greatest realism in home theatre installations it is important to balance the speakers and adjust the acoustic image to match the size of the screen. With smaller screens it may be more realistic to have the left and right speakers closer together than you might for audio alone. Adjust the levels of the three front speakers to get a smooth transition of sounds as they pan across the screen. Adjust the level of the surround speakers so that, except for special effects, your attention is not unduly attracted to them. Sit in all likely listening positions when deciding on the optimum levels. Consult your decoder manual for further information on how to set the levels. The speaker drive units are magnetically shielded such that the stray magnetic field outside the boundaries of the cabinet, except the front, is too low to cause distortion of the television picture in the vast majority of cases. There are, however, some extremely sensitive televisions ­ some that even have to be adjusted according to their alignment with the earth's magnetic field. [. . . ] The grille fabric may be cleaned with a normal clothes brush whilst the grille is detached from the cabinet. Avoid touching the drive unit diaphragms, especially the tweeter, as damage may result. Förvissa dig om att den positiva terminalen (markerad med + och röd färg) ansluts till förstärkarens positiva anslutningskontakt och den negativa terminalen (markerad med ­ och svart färg) ansluts till förstärkarens negativa anslutningskontakt. [. . . ]