User manual B&W LM 1

[. . . ] Its neat shape, flexible mounting bracket and small foot ensure that it comfortably fits the modern lifestyle. Please read this manual fully before unpacking and installing the product. It will help you to optimise its performance. [. . . ] Hang the speaker on the screws and then tighten the screws. Finally screw in the two remaining screws at the bottom of the mounting base and refit the rubber covers. WARNING: YOU SHOULD USE SUFFICIENT QUALITY, SIZE AND NUMBER OF CORROSION-PROOF FIXINGS TO AN AREA OF WALL OF SUFFICIENT STRENGTH TO ENSURE THAT THE SPEAKER IS SAFELY SUPPORTED. UNPACKING (figure 1) · Fold the carton flaps right back and invert the carton and contents. · Lift the carton clear of the contents. We suggest you retain the packing for future use. POSITIONING (figure 2) Position the speakers at the centre of the listening area approximately at the corners of an equilateral triangle. Keep the speakers at least 1. 5m apart to maintain left-right separation. For best results we recommend you stand the LMTM1 on a shelf or attach it to a wall. Stray magnetic fields The speaker drive units are magnetically shielded such that the stray magnetic field outside the boundaries of the cabinet, except the front, is too low to cause distortion of the television picture in the vast majority of cases. There are, however, some extremely sensitive televisions ­ some that even have to be adjusted according to their alignment with the earth's magnetic field. If you have a problem, first degauss the television set with the speaker in place. Some have a button specially for this purpose. If not, switch off the set at the mains for 15 minutes and switch on again. Merely putting the set into standby mode is not sufficient. If you still have a problem, try moving the speaker either forwards or backwards a little to get a more favourable juxtaposition, or space the speaker further from the television until the distortion disappears. Because of the higher stray magnetic field in front of the speaker, we recommend you keep magnetically sensitive articles (computer discs, audio and video tapes, swipe cards and the like) at least 0. 2m from the speaker. CONNECTIONS (figure 5) All connections should be made with the equipment switched off. If the speaker cable has been channelled or routed through the mounting surface the centre rubber plug in the base should be removed and the cable then routed through the exposed aperture. [. . . ] B&W Loudspeakers of America, 54 Concord Street, North Reading, MA 01864-2699 Tel: (1978) 664 2870 Fax: (1978) 664 4109. B&W Loudspeakers (Asia) Ltd, Flat U, 11F Camelpaint, Building Block 111, 60 Hoi Yuen Road, Kwun Tong, Kowloon, Hong Kong. Tel: (8522) 790 8903 Fax: (8522) 341 2777. [. . . ]