User manual B&W PV1

[. . . ] That means you'll experience impact and clarity, involving spatial qualities most often missing when listening through headphones or less-capable loudspeaker systems. And it's `Made for iPod', which means that Apple Inc. Has certified it for seamless use with today's most popular music source. with its airship-inspired shape , distinctively styled by Native Design , London , Zeppelin is simple and intuitive to use. [. . . ] If you remove your iPod/iPhone while it is the selected source, Zeppelin will automatically go into standby after 5 minutes to reduce power consumption. There are three ways to adjust Zeppelin's volume. If your iPod/iPhone is docked, and it is a Group D or Group E device, its own volume control can be used to alter Zeppelin's volume level, which is also displayed on the iPod/iPhone's screen. For the touch screen of devices in Group E, use the slider volume control at the bottom of the screen. for Group D iPods , use the click wheel. When using the volume control of a docked iPod/iPhone, its own internal volume level is not affected, but is retained at its original level for when you remove the iPod/iPhone and go back to using headphones. The click wheel and display of Group B and Group C iPods will not function in this way. As you alter the volume level, Zeppelin's LED will flash. As you approach the maximum level, the LED will turn white. Once you reach either the maximum or minimum level, the LED will turn red. On Zeppelin itself, press on the upper section of the long button, marked + to increase the volume and the lower section, marked - to decrease it On the remote, press the + button to increase the volume and the - button to decrease it. Com Download the Zeppelin Connectivity Guide from our web site for more details. The devices of Group E ­ iPod touch and iPhone ­ can connect to the Internet and stream both video and audio content. While streaming, their iPod function is paused and Zeppelin's LED will slowly flash blue. In this state Zeppelins with serial numbers starting Z-0 and with the original software installed mute their amplifier and the streamed audio content will not be heard. To enable streamed content to be heard via this Zeppelin version, first upgrade the software, which you can access from the Zeppelin page of our web site www. The later software by default will still mute-on-pause with Z-0 models, but this may be defeated by first placing Zeppelin into standby (when the LED will glow red). press and hold the remote's play/pause button until the LED blinks (approximately 2 seconds). A single off/on indicates that the mute-on-pause has been defeated and streamed audio may be heard. a double off/on/off/on indicates that mute-on-pause has been restored. Zeppelins with serial numbers starting with Z-1 or higher will stream Internet content as delivered. When streaming from the Internet (eg from You Tube), the play/pause, forward and back buttons of Zeppelin's remote will not duplicate the on-screen controls of the touch/iPhone. [. . . ] Upgrades and instructions on how to install them will be posted on our web site: www. Com To install upgrades, you will need to connect Zeppelin to a USB output on your computer using a standard USB device cable. This is the same type of cable that is used to connect USB printers, for example. if Zeppelin's current software version is 1. [. . . ]