User manual B&W WP1

[. . . ] WP 1 TM WEATHERPROOF MONITOR OWNER'S MANUAL Figure 1 WPTM1 WEATHERPROOF MONITOR OWNER'S MANUAL English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Français . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Deutsch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Español. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Figure 2 Português. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Italiano . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Nederlands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 "esky . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Polski . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Figure 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Slovensko. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Suomi . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Svenska. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Figure 4 INTRODUCTION Thank you for choosing B&W. The WP 1 is designed to operate in environmental conditions where a conventional loudspeaker would soon suffer, if work at all. [. . . ] Incorrect connection can result in poor imaging and loss of bass. Always make sure all the terminal caps are screwed down tight, as otherwise they may rattle. Ask your dealer for advice when choosing cable. Keep the total impedance below the maximum recommended in the specification and use a low inductance cable to avoid attenuation of the highest frequencies. MOUNTING (figure 3) For complete flexibility, a number of mounting variations are catered for. Two tapped holes are provided at the base of the rear of the cabinet. They will take either 1 UNC /4" or M6 fixings to cater for a number of commercially available mountings. The supplied mounting bracket contains slots and keyhole fixings. We recommend that the slots are used for permanent fixing (the slots allows for a small amount of repositioning during mounting) or where the speaker may be subject to movement or jolts (on a yacht for instance). The keyhole fixings allow the speaker to be easily removed or repositioned at some point in the future. The cut-out in the centre of the bracket allows the speaker cable to be routed directly through the bracket for connection to the terminals (see `Connections'). WARNING: You should use sufficient quality, size and number of corrosion proof fixings to an area of wall or ceiling of sufficient strength to ensure that the speaker is safely supported. The WPTM1 can be mounted either horizontally or vertically but consideration should be given to angling the speaker either left and right or up and down by moving the speaker relative to its mounting bracket. This is achieved by slackening the knobs at the top and bottom of the speaker, swivelling the speaker and then re-tightening the two knobs (hand tightening should be sufficient to keep the speaker in place). Please read this manual fully before unpacking and installing the product. It will help you to optimise its performance. [. . . ] Copyright © B&W Loudspeakers Ltd. B&W Loudspeakers Ltd, Meadow Road, Worthing, BN11 2RX Tel: +44 (0) 1903 524801 Fax: +44 (0) 1903 524725 http://www. bwspeakers. com [. . . ]