User manual B-52 LG100A

[. . . ] Unplug the LG-100A during lightning storms or when un-used for long periods of time. Refer all servicing to qualified personnel. Servicing is required when the LG-100A has been damaged in any way such as when power-cord or plug is damaged, liquid has been spilled, been exposed to moisture or rain, does not operate normally, or has been dropped. To reduce the risk of fire or electric shock, do not expose the LG-100A to rain or moisture. 0 10 0 10 0 10 GAIN SW. 0 10 0 10 0 10 INPUT GAIN1 GAIN2 CONTOUR BASS MIDDLE TREBLE 1 2 3 4 5 6 7 8 GETTING TO KNOW YOUR LG-100A (1) (2) (3) (4) Input: Connects the electric guitar. [. . . ] LED for Clean Channel indicates when clean channel is in use. Level: Controls the complete signal of the clean channel. Bass: Provides desired amount of bass response in clean channel. Middle: Provides desired amount of middle frequency equalization in clean channel. Treble: Provides desired amount of high frequency equalization in clean channel. Reverb: Adjusts the reverberation effect. Master: Controls the overall signal level of the guitar amplifier. Power Switch: Turns the amplifier ON or OFF. AMPLIFIER PRECAUTIONS Do not attempt to service the LG-100A by yourself. Refer all servicing to a B-52 Authorized dealer. Service is required when the LG-100A has had liquid spilled on it or has been damCAUTION RISK ELECTRIC SHOCK aged in any way, the OFamplifier has been DO NOT OPEN exposed to rain or moisture, does not operate normally or has been dropped. REAR PANEL VIEW CC CAUTION S/No. : RISK OF ELECTRIC SHOCK DO NOT OPEN 0 10 CAUTION - TO REDUCE THE RISK OF FIRE, REPLACE ONLY WITH THE SAME TYPE OF FUSE. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE LEVEL FOOT SWITCH 0 10 0 10 LINE OUT 24 CHANNEL REVERB GAIN 25 26 27 LEVEL RETURN LEVEL SEND 28 29 30 31 (27) (28) (29) (30) (31) Footswitch Jack: Connects a footswitch to switch reverb ON and OFF. Return Level: Controls the returning signal level. Return Jack: Connects the guitar amplifier to out put of an effects unit. Send Level: Controls the sending signal level. Send Jack: Connects the guitar amplifier to input of an effects unit. WARNING: SHOCK HAZARD! To reduce the risk of fire or electrical shock, do not expose this unit to rain or moisture. Do not operate your LG-100A near a pool or other standing water. Make sure all blades on the polarized power plug are fully inserted into the power source. Ensure the powercord is not stretched, pinched or otherwise abused. Ensure the power cord is routed to avoid foot traffic. Your LG-100A amplifier should be cleaned only with a dry cloth. 3 FEATURES WARRANTY Thank you for choosing this B-52 Pro-Audio sound product. B-52 manufactures some of the world's best sounding and most reliable professional speaker systems and components. Sound Systems, Inc. , manufacturers of B-52, takes great pride in thoroughly testing each B-52 product prior to shipment. Please read the warranty terms and conditions below and carefully read the provided Limited Warranty Card for additional terms and conditions. [. . . ] If a product must be returned directly to E. T. I. for warranty replacement/repair, a Return Authorization Number (RAN) must be obtained from our Customer Service Department prior to shipping the product. You may obtain RAN by calling 800-344-4ETI. 100 Watts RMS into 8 Ohms/120 Watts RMS into 4 Ohms 1/4" High Input Jack Overdrive Channel with Gain 1, Gain 2 with Contour, Gain switch, 3-band EQ, and Level Control Clean Channel with Level 3-Band EQ Controls Master Reverb & Volume Foot Switch for Channel Select/Reverb On/Off/Gain Select Push Switch for Channel/Gain Select Headphones Line Out Effects Send/Return with Level Controls External Speaker Jacks Ground-Lift Switch SPECIFICATIONS Output Power Input Impedance: Maximum Input Level: Power Consumption: S/N Ratio: Affects Send: Nominal Output Level: Effects Return Impedance: Optimum Input Level: Line Out: Phones: Equalization: 100 Watts RMS at 8 Ohms at 1% THD 120 Watts RMS at 4 Ohms at 1% THD 500K Ohms -45dB 160 Watts Greater Than 100 dB Load Impedance 1K Ohm or Greater -8 dB 100K Ohms -8 dB 0dB / 1V RMS 60mW into 8ohm Bass : +/- 15dB at 50Hz Middle : +/- 10dB at 600Hz Treble : +/- 18dB at 3KHz 24. 5" (W) x 11" (D) x 10" (H) 35 lbs Dimensions: Weight: E. T. I. Sound Systems is dedicated to product excellence and therefore continuously attempts to improve each and every model we manufacture. [. . . ]