User manual B-52 ST100A

[. . . ] IMPORTANT SAFETY INSTRUCTIONS! 1) 2) 3) 4) 5) 6) 6) 7) 8) 9) Read these instructions. DO NOT turn on the ST-100A without the loudspeaker connected. Be extra cautious when moving the ST-100A during rain or while transporting it over wet surfaces as water might splash onto the amplifier. Do not block any ventilation openings and operate in accordance with manufacturer's instructions. [. . . ] Ensure the power cord is routed to avoid foot traffic. LEVEL FIRE, REPLACE ONLY WITH THE SAME all the way to the left you will experience clean sounds. Your ST-100A amplifier should be cleaned only with a dry cloth. WARNING: TO REDUCE THE RISK OF all the way to the right will produce moderate levels of distortion. 2. ON 1 2 ON All-Tube Professional Amplifier ST-100A PHONES MASTER 0 10 REVERB 0 10 TREBLE 0 10 MIDDLE 0 10 0 BASS 10 VOLUME 0 10 3 4 MASTER 5 6 7 CLEAN 8 9 ST-100A SEND RETURN GAIN & CHANNEL REVERB All-Tube Professional Ampl ST-100A RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION CAUTION: TO REDUCE THE RISK OF FIRE, REPLACE ONLY WITH THE SAME TYPE OF FUSE. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE LINE OUT 21 LEVEL 22 23 LEVEL EFFECTS 24 25 LEVEL 26 FOOT SW 28 27 GAIN & CHANNEL REVERB CC S/No. : SEND RETURN All-Tube Professional Ampli ST-100A 21 4 21. LINE OUT JACK: Connects the ST-100A to an external linelevel device such as a mixing board. LINE OUT LEVEL CONTROL: Controls the output capacity of the Line Out Level. EFFECTS - SEND JACK: Connects to the ST-100A to the input off an effects unit. EFFECTS ­ SEND LEVEL: Controls the sending level output to an effects unit. 25. EFFECTS ­ RETURN LEVEL: Controls the input capacity of 22 23 24 25 26 27 28 the returning signal from an effects unit. EFFECTS ­ RETURN JACK: Connects the ST-100A to the output of an effects unit. FOOTSWITCH ­ GAIN AND CHANNEL SWITCH: Switch between Gain 1 and Gain 2 in the overdrive Channel. Also switches between clean and overdrive channel. FOOTSWITCH ­ REVERB INPUT JACK: Connects footswitch to turn Reverb On/Off. SPEAKER SELECT SWITCH: Allows you to select appropriate CH. SW. OVERDRIVE GAIN SW. INPUTS E CH. SW. VOLUME 0 10 TREBLE 0 10 MIDDLE 0 10 0 BASS 10 CONTOUR 0 10 GAIN2 0 10 GAIN1 0 10 LOW HIGH ifier 10. CHANNEL SWITCH: Push switch selects between the clean between Gain 1 and Gain 2 controls. Activated LED lights and overdrive channels. Activated LED lights indicate which indicate which channel is currently use. OVERDRIVE10 CHANNEL ­ 10 GAIN 1: Adjusts the amount of channel is10 use. [. . . ] Products replaced or repaired under this warranty will be returned via ground-shipping-within the United States-freight prepaid. is not responsible for costs associated with expedited shipping, either to E. T. I. or the return of the product to the customer. INCIDENTAL OR CONSEQUENTIAL DAMAGE: In no event will E. T. I. [. . . ]