User manual BABY JOGGER CITY ELITE SINGLE

[. . . ] Damage resulting to stroller will not be covered under warranty. · Warning: Child may slip into leg openings and strangle. Never use in reclined carriage position unless safety harness is properly fastened. · Accessories which are not approved by the manufacturer or distributor shall not be used. [. . . ] The stroller will frame will click and lock into place. 6. Turn stroller over. 2 To fold: Unsnap safety strap from frame and pull up on fold strap. 1 Front Wheel Rear Wheels 1 To install front wheel, lay stroller back so the handle is resting on the floor. Lock front wheel to prevent the forks from swiveling. 2 Insert the front wheel into the fork tips by aligning the axle flats with the fork tip flats. 1 To install, gently slide the rear wheel's axle into the hole in the frame until the wheel clicks into place. 2 To remove, simply press the wheel button while gently sliding the wheel away from the frame. 3 Tighten by turning the wheel lever clockwise while holding the opposite side. 2 4 Close the wheel lever making sure that it is flush with the tubing. Be sure not to overtighten. 3 Safety Harness 3 To buckle the harness: Simply push side buckle into center buckle until it locks into place. To unbuckle: Push one side of the center button and pull the corresponding side buckle away from the center buckle. Repeat to unbuckle other side. 1 Unclip top of shoulder strap from the seat and re-clip on the pair of seat loops closest to your child's shoulder height. Brake 2 To adjust the shoulder and crotch strap length: Remove the shoulder pads and slide the plastic guide up or down to lengthen or shorten. · Simply push brake pedal down to engage rear parking brake and lift up to release. Warning: always use the crotch strap in combination with the shoulder straps and waist belt. 4 Warning: Engage parking device before loading and unloading passenger. 5 Canopy Seat Warning: always be sure the safety strap is securely snapped onto the frame before using stroller! 1 To attach canopy to frame, simply slide canopy axle into top hole of the bracket on the frame, until you hear it click into place. The bottom hole can be used for accessories (sold separately), and they should be inserted into bracket the same way as the canopy. To remove canopy: stand facing the stroller and press the bracket buttons with index finger while removing canopy from the bracket. 1 Secure seat fabric to frame by lining up snap placement on frame and fabric. 2 Secure seat straps around the bottom of the frame, behind the front wheel. Thread one seat strap through the D ring of the other strap, and fasten both Velcro sides firmly together. 3 Secure safety straps to both sides of the frame before use. To fold stroller: Remove child from seat. Unsnap safety straps from frame and pull upwards on the fold strap with a gentle tug. 2 Snap webbing together around top of frame. 3 Secure canopy around frame with Velcro tab. 4 Once canopy is in place, attach the console by aligning the Velcro strips on the console and canopy. 4 Be sure that fold strap rings are secured to the frame before use. 7 6 Raised Kicker Reclining Seat 1 To use the raised kicker, pull up on seat flap above the footplate, and remove the kicker stand from storage pocket. Attach the kicker stand to the seat with the hooks provided under seat flap. 2 Attach kicker stand by wrapping both sides of the webbing under the footplate. Thread one side of the velcro webbing through the D ring of the other side, and secure velcro together. 3 When not using the raised kicker, tuck the kick stand and the webbing straps into the pocket provided under the seat. 1 To recline: Pinch the clamp behind the seat, and slide it down to desired recline. Pull seat down on both sides to match recline position of clamp. Basket 1 The Elite basket is sewn onto the base of the seat. To secure the seat basket to the frame, simply secure the velcro flap around the wheel tube. Attach the basket to the front of the stroller frame, around the footplate, with the velcro strap that is at the front of the basket. If the seat is already assembled on the frame, you will need to lift up the seat fabric at the footplate in order to attach the basket. · Weather Cover: If desired, pull weather cover down and over the seat back mesh. When not in use, roll weather cover up and fasten with elastic loop and barrel provided under top of the seat fabric. 8 Reverse steps to return to the upright position. 9 Quick Fold Technology Simple Lift & Fold (Patented) Warning: always be sure the safety strap is securely snapped onto the frame before using stroller! In Motion Steering · Steering your stroller is simple: It is balanced to turn with just a light touch on the handlebar without having to lift the front wheel. In the Dark · Since we are concerned about the safety of you and your child, we recommend that you not use your stroller at night. However, if you choose to, please attach reflective strips to the wheels and the seat. Bicycle lights can also be mounted on the handle crossbar. These accessories can be found at most bike stores. Maintenance To fold stroller: 1 Remove child from seat. Pull upwards on the fold strap with a gentle tug. [. . . ] However, if you do store it outside, using a tarp will help protect against weather wear. This warranty specifically excludes claims for indirect, incidental, or consequential damages. The implied warranties of merchantability and fitness for a particular purpose is according to the specific warranty period for this model unit at time of purchase. some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. [. . . ]