User manual BABYLISS E826E

[. . . ] Made in China ENGLISH E825E Please carefully read the instructions for use below before using the appliance.  cutting guide for 20 lengths (from 1 mm to 20 mm, in 1 1 mm increments) + length lock system 4.  heel to adjust the cutting length W 5. [. . . ] Plug the trimmer, in the OFF position, into the mains and switch ON (if the battery is very weak, wait about 1 minute). Use only the adapter that is supplied with the trimmer. HANDLING THE COMB GUIDE NOTE: Always put the comb guide on BEFORE turning the trimmer on, and turn the trimmer off before removing it. To remove or replace the comb guide, first set the comb guide to the triangle mark beyond position 20 (Fig.  1) and, with the motor off, pull the guide up to remove it (Fig.  2), press the guide down then turn the dial to put it on (Fig. TURNING IT ON AND USING IT To adjust the cutting length of the trimmer, turn the dial. The length-lock system allows you to lock the cutting length setting (Fig. Once the cutting length is selected, slide the switch to the «lock» position. To change the cutting length, make sure you unlock the switch before using the dial. You can change the cutting length at any time. Make sure you hold the comb head flat against the skin. That is, the tips of the teeth and the little corners protruding from the comb should always be in contact with the skin. If not, the precision of the cut may change (Fig. [. . . ] The BaByliss oil is specially formulated for the trimmer, it does not evaporate nor does it slow the blades. It is possible to obtain replacement blades when these are worn out or damaged. Selvsmørende kniver Knivene på din skjeggtrimmer er forsynt med en pute innsatt med olje som sørger for å tilføre den mengde olje som er nødvendig for at skjeggtrimmeren skal fungere best mulig, gang etter gang. [. . . ]