User manual BALAY 3FE2760B

[. . . ] 26 Normal noises heard during appliance operation . 28 4 Safety information Read these instructions carefully. Only after doing this will you be able to operate your appliance properly. Keep the operating and assembly instructions in a safe place. [. . . ] It is for this reason that you are recommended to use a hotplate which matches the diameter of the pan. No pan or incorrect size pan Empty pans or pans with a thin base Pan detection 11 Double or triple hotplate These areas can detect pans of different sizes. The area will automatically adapt, depending on the pan material and its properties, activating only a single area or an entire area and supplying the right level of power for best cooking results. Getting to know your appliance The operating instructions are valid for a range of cooking hobs. A general overview of the models is provided on page 2. The control panel Indictors for heat setting 1 9 efficiency 0 residual heat H/h Powerboost function n Control surface for Ñ childproof lock Indicators for time program function Control surfaces for heat setting selection Control surface for @ main switch Control surfaces for 0 time program function ð double hotplate æ extended cooking zone 12 The hotplates Hotplate Switching on and off Single radiation cooking Ensure the pan is the right size. zone Single induction cooking zone l m * Double radiation cooking zone* Radiation extended cooking zone* Ensure the pan is the right size. Press the l symbol Press the m symbol Hotplate activation: The corresponding indicator lights up. Only pans which are suitable for induction cooking should be used on induction hotplates; see section on "Suitable pans". Residual heat warning light The hob has a residual heat warning light for each hotplate to show those which are still hot. Avoid touching the hotplate when this warning light is on. Although the hob is switched off, the warning light will stay lit while the hotplate is hot. When the pan is removed before the hotplate is turned off, the s/t indicator and the selected heat setting will be displayed alternately. 13 Programming the hob This section shows how to adjust a hotplate. The table gives the settings and cooking times for various dishes. Switching the hob on and off To switch on The hob is switched on and off using the main switch @. The ± indicator next to the @ symbol lights up. A beep sounds and the ± indicator goes out. The function has now been activated. It is deactivated as follows Follow the steps below: 1. The letter n will no longer be displayed and the hotplate will return to heat setting j. The Powerboost function has been deactivated. In certain circumstances, the Powerboost function may be deactivated automatically to protect the internal electronic components of the hob. d Timer function This function can be used in two different ways: - to switch a hotplate off automatically - as a cooking timer Switching a hotplate off automatically Enter the time period for the required hotplate. The hotplate will switch off automatically once this time has elapsed. 20 Programming instructions The hotplate must be connected. Select the required hotplate and heat setting. The indicator lights up on the active hotplate and the kk indicators light up on the time program function display. Press the + or - symbols for the selected hotplate. + symbol: 30 minutes - symbol: 10 minutes ) 3. Set the required time using the + or - symbol. After a few seconds, the timer will start to count down. [. . . ] Wait a few seconds before connecting it again. If the indication continues, notify the technical assistance service. Disconnect the cooking hob from the mains. Wait a few seconds before connecting it again. [. . . ]