User manual BALAY 3FEB2315

[. . . ] 19 21 3 Table of contents Basic settings . 25 Normal noises heard during appliance operation . 27 4 Safety information Read these instructions carefully. Only after doing this will you be able to operate your appliance properly. [. . . ] These areas can detect pans of different sizes. The area will automatically adapt, depending on the pan material and its properties, activating only a single area or an entire area and supplying the right level of power for best cooking results. No pan or incorrect size pan Empty pans or pans with a thin base Pan detection Double or triple hotplate 11 Getting to know your appliance The operating instructions are valid for a range of cooking hobs. A general overview of the models is provided on page 2. The control panel Control surface for Ñ childproof lock Indicators for time program function Control surface for T time program function Control surfaces for heat setting selection Control surface for @ main switch Indictors for heat setting 1 9 efficiency 0 residual heat H/h Powerboost function n The hotplates Hotplate Single cooking zone Switching on and off Ensure the pan is the right size. Only use pans which are suitable for induction cooking, see the section on Suitable pans". 12 Residual heat warning light The hob has a residual heat warning light for each hotplate to show those which are still hot. Avoid touching the hotplate when this warning light is on. Although the hob is switched off, the warning light will stay lit while the hotplate is hot. When the pan is removed before the hotplate is turned off, the s/t indicator and the selected heat setting will be displayed alternately. Programming the hob This section shows how to adjust a hotplate. The table gives the settings and cooking times for various dishes. Switching the hob on and off The hob is switched on and off using the main switch @. The ± indicator next to the @ symbol lights up. A beep sounds and the ± indicator goes out. The residual heat warning light stays on until the hotplates have cooled down completely. The hob is automatically switched off when all the hotplates have been switched off for a set period of time. On hotplate number 1, the Powerboost function can be activated at any time. 18 It is activated as follows Follow the steps below: 1. The letter n appears on the hotplate display. The function has now been activated. It is deactivated as follows Follow the steps below: 1. The letter n will no longer be displayed and the hotplate will return to heat setting j. The Powerboost function has been deactivated. In certain circumstances, the Powerboost function may be deactivated automatically to protect the internal electronic components of the hob. d Timer function This function can be used in two different ways: - to switch a hotplate off automatically - as a cooking timer Switching a hotplate off automatically Enter the time period for the required hotplate. The hotplate will switch off automatically once this time has elapsed. 19 Programming instructions The hotplate must be connected. Select the required hotplate and heat setting. The indicator lights up on the active hotplate and the kk indicators light up on the time program function display. Press the + or - symbols for the selected hotplate. + symbol: 30 minutes - symbol: 10 minutes ) 3. [. . . ] Wait a few seconds before connecting it again. If the indication continues, notify the technical assistance service. Disconnect the cooking hob from the mains. Wait a few seconds before connecting it again. [. . . ]