User manual BALAY 3VC240BD

[. . . ] EN Operating instructions Dishwasher en Index 4 5 6 7 9 10 11 11 Overview of programmes . 13 14 15 15 17 18 20 20 Safety instructions . . 3 en Safety instructions Before switching on the appliance for the first time, read the installation and operating instructions carefully; they contain important information with regard to installation, use and maintenance of the appliance. Retain the installation and operating instructions for a possible second user. [. . . ] This can be remedied by: using a more intensive wash programme or dispensing a larger amount of detergent or using detergents which contain chlorine. See detergent packaging to determine whether a detergent is suitable for silver parts. If you have further questions, we recommend that you contact the advice centres of the detergent manufacturers. Unloading the dishwasher At the end of the programme leave the utensils to cool down for approx. Select a programme with the programme selector (rotate in a clockwise direction only). Attention If the programme selector 3 is fully rotated once in a clockwise direction, the detergent dispenser opens and dispenses its contents. The detergent dispenser must then be refilled. End of programme The programme ends when the pump noise stops and the programme selector has reached the original position 0 (A). Exception: The "Prerinse" programme ends when mark "B" is reached. The programme selector can now be rotated in a clockwise direction to the original position 0 (A). If the programme selector is not rotated manually to the original position 0 (A), the programme selector will automatically run to the original position 0 (A) after a specific time. Switching off the appliance Switch off the main switch 2 , the door unlocks. It is not necessary to adjust the programme selector. 14 en Special functions Programme sequence indicator The programme selector rotates during the wash cycle in a clockwise direction and indicates the programme status. The programme selector waits until the appliance has heated up the water. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. Therefore you should occasionally have a careful look inside your dishwasher. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which has the highest wash temperature. Clean the door seal: Wipe the door seal regularly with a damp cloth to remove any deposits. Changing the programme Switch off the main switch 2 . Set the programme selector 3 to the desired new programme (rotate in a clockwise direction only!). Check whether the detergent dispenser is still closed. Switch on the main switch 2 again. Interrupting the programme Switch off the main switch 2 . To continue the programme, switch on the main switch again. Do not open the appliance door if the machine has already heated up or if hot water is flowing in. Salt Check the salt refill indicator. If required, top up the salt. Rinse aid Check the liquid level in the dispenser. If required, top up with rinse aid. Filters The filters 23 keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a microfilter for coarse dirt and a fine flat filter. [. . . ] Valuable raw materials can be reclaimed by recycling old appliances. Pull out the mains plug of the redundant appliance. Cut off the power cord and discard with mains plug. To prevent children from locking themselves in the appliance and suffocating, destroy the door lock and childproof lock (if fitted). [. . . ]