User manual BALAY 3VF341ND

[. . . ] EN Instructions for use Dishwasher en Index 4 6 7 8 9 10 11 Detergents . 14 17 18 19 21 24 25 26 Safety instructions . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. [. . . ] The programmes supplied with your appliance are indicated on the fascia. Type of crockery e. g. china, Nonpots/pans, delicate cutlery, glasses, etc. Type of food remains Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot stuck on hard Mixed Delicate Mixed Soups, potatoes, pasta, rice, eggs, roast or fried food Coffee, cakes, milk, sausage, cold drinks, salads very little Amount of food remains Condition of food remains Wash programme a little loosely attached Rinse off if the dishes have been stacked for several days in the dishwasher prior to washing. Intensive Normal 70° 65° Eco 50° Gentle 40° Quick 45° Pre-rinse Programme sequence Pre-rinse 50° Wash 70° First rinse Second rinse Third rinse Rinse-aid 70° Drying Pre-rinse Wash 65° First rinse Second rinse Rinse-aid 70° Drying Pre-rinse Wash 50° Main rinse Rinse-aid 65° Drying Pre-rinse Wash 40° Main rinse Rinse-aid 55° Drying Wash 45° Main rinse Rinse-aid 55° Pre-rinse Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the amount and condition of food remains, with the details contained in the programme overview. You will find the appropriate programme information in the introduction. If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. End of programme The programme has come to an end when the PROGRAMME END indicator 3 and the indicator for the selected programme are both lit up. Apart from this, the end of the programme is indicated by a buzzer. This function can be changed as follows:­ Hold down the function button C and switch on the main switch 1 . Each depression of function button C changes the buzzer in 4 stages (from off to loud). The setting is stored. Programme specifications The programme specifications can be found in the summary of instructions. Programme specifications refer to normal conditions. Greater deviations may occur due to: varying amounts of dishes water supply temperature water pipe pressure ambient temperature mains voltage tolerances and the tolerances specific to the appliance (e. g. temperature, amount of water, etc. ) The water consumption values refer to a set water hardness value of 2. Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 7 is pressed For appliances with top basket feature: If only the top basket is loaded, press the top-basket button 6 . The programme starts automatically. 18 en Programme interruption Carefully open the door, it could happen that water splashes out of the appliance. Only open completely when the spray arm no longer turns. If the programme is already in "drying" mode, an acoustic signal reminds you to close the appliance door or to abort the programme. If warm water is connected or if the machine is already heated up and the appliance door has been opened, leave the door slightly ajar, then close it, otherwise the appliance door can jump open through the expansion. In order to continue the programme flow, switch the main switch ON again and close the door. Maintenance and care You can help prevent faults by checking and maintaining your appliance regularly. This will save time and reduce problems. [. . . ] Only this circuit breaker guarantees compliance with the currently valid regulations. Installation The required installation dimensions can be found in the installation instructions. Using the height-adjustable feet, adjust the appliance until it is level. Ensure that the appliance is standing firmly. Waste water connection See the installation instructions for the required connection steps. If required, attach a siphon with drainage spigot. [. . . ]