User manual BALAY 3VS300BA

[. . . ] en Instructions for Use Dishwasher 9000 405 402 (8811) en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 11 12 13 14 14 14 15 15 15 Hygiene . Terminating the programme (Reset) Changing the programme . Overall condition of the machine Filters . 15 15 15 15 15 15 15 16 16 16 16 16 16 17 17 17 18 18 19 19 19 19 20 21 22 22 22 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . [. . . ] To delete the preselected starting time, keep pressing the Preselected starting time button 5 until none of the displays 3 h, 6 h or 9 h is lit. You can change your programme selection at any time until the programme starts. Interrupting the programme Switch off ON/OFF switch 1 . If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. Terminating the programme (Reset) Press Start button 4 for approx. The remaining programme sequence lasts approx. The End display 10 is lit, switch off ON/OFF switch 1 . End of programme The programme has ended when the End display 10 is lit. Switching off the appliance Short time after the end of the programme: Switch off ON/OFF switch 1 . Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme When the START button 4 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). 16 en Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Close the door. Rotate programme selector 3 until the "Check water supply" display 9 flashes. The "Check water supply" display 9 flashes. Change the setting as follows: By rotating the programme selector 3 , you can switch on intensive drying (End display 10 is lit) or switch off intensive drying (End display 10 is not lit). The setting is saved. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly clean door seal with a damp cloth. [. . . ] holiday home), empty the appliance completely (see Transportation). Turn off the tap, disconnect supply hose and drain water. 24 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. Please dispose of the individual parts separated according to type. Please ask your dealer or inquire at your local authority about current means of disposal. Packaging All plastic parts of the appliance are identified with internationally standardised abbreviations (e. g. [. . . ]