User manual BALAY 3VS932IA

[. . . ] instruction manual 9000 460 749 (8909-1) EN Dishwasher y www. balay. es 1 2 34 56 7 8 9 10 Reinigen fertig in 1:08 Std. ABC 12 11 Reset 3 sec. 20 21 22 23 24 25 26 27 28 29 30 31 32 33 en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 16 16 16 16 16 17 17 17 18 18 18 18 19 19 19 19 19 20 20 21 21 22 22 22 23 23 24 24 24 25 25 25 26 26 26 27 27 27 27 28 28 28 Safety instructions . 8 Switching off water softening system . [. . . ] ­ Close the door. 17 en Automatic switch off after end of programme or interior light* * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The setting can be selected from : to :. : Appliance does not switch off automatically. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. When the door is closed the light is off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. Appliance switches off after 120 min. Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. ­ Close the door. : : ­ Open the door. ­ Hold down programme button # and press START button )" until : . . . The LED for button # flashes and the digital display 8 displays the factory setting : . ­ Keep pressing programme button # until the value : . . . is indicated on the numerical display 8. To change the setting: ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : . ­ Close the door. Terminating the programme (Reset) ­ Open the door. [. . . ] ­ Loosen the fastening screws under the worktop. ­ Pull out the appliance, carefully pulling the hose behind. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. holiday home), empty the appliance completely (see Transportation). ­ Turn off the tap, disconnect supply hose and drain water. 27 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. [. . . ]