User manual BALAY 3VW500BA annexe 1

[. . . ] ­ Press and hold down the Start button A. ­ Rotate programme selector B until H:0. The factory-set value H:04 is lit on the digital display. [. . . ] * half normal load 2:15 1, 50 Water consumption in litres 15 Energy Consumption: kWh 2:00 1, 45 14 2:20 1, 05 14 1:10 0, 80 13 0:29* 0, 80 10 0:15 0, 05 4 Start programme Here we go . . . Additional options ** Express Wash (VarioSpeed) . . . is obtained by increased energy consumption at a constant cleaning and drying performance. for a few items, saves water, energy and time Flexibility . . . IntensiveZone . . . Washing pressure and washing temperature are increased slightly. The temperature is increased during the rinsing process. improves the drying result by increased temperature in the final rinse (Please take care with delicate dishes) Switch off the appliance Everything o. k. . . . ** depending on model Maintenance and care Filters . . . check, if required clean Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . rinse under running water . . . Screw on filter system NOTE MARK! Cleaning waste water pump ­ Pull out the mains plug ­ Remove filters and scoop out water ­ Lever off cover (­­>A) ­ Check area around the fan impeller for foreign objects ­ Click cover shut (­­>B) ­ Insert filters Spray arms . . . Remove blockages/deposits pull lower arm upwards . . . unscrew upper arm . . . clean spray nozzles under running water (if required use toothpicks) . . . insert lower arm . . . A B screw on upper arm tightly Rectifying minor faults yourself . . . Fault Possible causes . . . as it is worth doing it yourself! Remedial action Fault Utensils are not clean Sand or gritty residue on the utensils Possible causes Utensils are situated close together or one above the other Too little detergent Unsuitable programme selected Spray arm nozzles blocked Filters dirty, not seated firmly Spray arms blocked Remedial action Separate the utensils, prevent contact points. Follow manufacturer's instructions (detergent). Arrange the utensils so that the spray arms can rotate freely. Display " " display is lit Supply fitting jammed or calcified Open supply fitting. If the flow rate is less, replace the supply fitting. [. . . ] Never wash rusting parts in the appliance. Plastic/utensils discoloured Discoloration caused by food colourings (tomato sauce) Follow manufacturer's instructions (detergent). Discoloration is harmless; subsequent rinse cycles will cause it to fade. Rust on the cutlery More information can be found in the operating instructions Terminating the programme . . . While the programme is running, press the START button for approx. [. . . ]