User manual BALAY SMV40E00EU

[. . . ] ­ Hold down button > and press Start button until ­ Release buttons. The display flashes and the displays and "End" flash. <> °dH 0­6 7­16 Hardness range soft medium hard hard mmol/l 0­1, 1 1, 2­2, 9 3, 0­3, 7 3, 8­6, 2 Setting 0 1 2 3 ABC A are lit (= setting 1). Change the setting as follows: ­ Button < press until the required setting has been selected. The and "End" displays go out. [. . . ] is obtained by increased energy consumption at a constant cleaning and drying performance. for a few items, saves water, energy and time Flexibility . . . IntensiveZone . . . Washing pressure and washing temperature are increased slightly. The temperature is increased during the rinsing process. improves the drying result by increased temperature in the final rinse (Please take care with delicate dishes) Switch off the appliance Everything o. k. . . . ** depending on model Maintenance and care Filters . . . check, if required clean Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . rinse under running water . . . Screw on filter system NOTE MARK! Cleaning waste water pump ­ Pull out the mains plug ­ Remove filters and scoop out water ­ Lever off cover (­­>A) ­ Check area around the fan impeller for foreign objects ­ Click cover shut (­­>B) ­ Insert filters Spray arms . . . Remove blockages/deposits pull lower arm upwards . . . unscrew upper arm . . . clean spray nozzles under running water (if required use toothpicks) . . . insert lower arm . . . A B screw on upper arm tightly Rectifying minor faults yourself . . . Fault Possible causes . . . as it is worth doing it yourself! Remedial action Fault Utensils are not clean Sand or gritty residue on the utensils Possible causes Utensils are situated close together or one above the other. Remedial action Separate the utensils, prevent contact points. Follow manufacturer's instructions (detergent). Arrange the utensils so that the spray arms can rotate freely. Display " " display is lit Supply fitting jammed or calcified. Open supply fitting. If the flow rate is less, replace the supply fitting. [. . . ] Extraneous rust Use dishwasher­proof cutlery. Never wash rusting parts in the appliance. Plastic/utensils discoloured Discoloration caused by food colourings (tomato sauce). Rust on the cutlery Follow manufacturer's instructions (detergent). [. . . ]