User manual BALTUR PRIMAVERA CA 21 SCHEMA ELEC

[. . . ] Pass them on to possible new owners of the appliance. Your appliance is supplied with a 13amp fused plug that can be plugged into a 13amp socket for immediate use. Before using the appliance please read the instructions below. WARNING: THIS APPLIANCE MUST BE EARTHED. [. . . ] The diagrams may not directly represent the appliance purchased. For more complex features, consult the following pages. GB TEMPERATURE control Removable lidded shelf with EGG TRAY FREEZER and STORAGE compartment SHELVES• Removable multipurpose SHELVES• Drain for DEFROST WATER FRUIT and VEGETABLE bin Compartment for a 2 LITRE BOTTLE BOTTLE shelf Levelling FEET • Varies by number and/or position. 5 Start-up and use GB Starting the appliance !Before starting the appliance, follow the installation instructions (see Installation). Before connecting the appliance, clean the compartments and accessories well with lukewarm water and bicarbonate. Insert the plug into the socket and ensure that the internal light illuminates. Turn the TEMPERATURE ADJUSTMENT knob to an average value. After a few hours you will be able to put food in the refrigerator. SHELVES: with or without grill. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Height can be adjusted without complete removal of the shelf. Using the refrigerator to its full potential • Use the TEMPERATURE ADJUSTMENT knob to adjust the temperature (see Description). • Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). • Remember that cooked foods do not last longer than raw foods. until the ideal storage conditions have been restored, before placing food in the freezer compartment. GB Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia. • The removable accessories may be soaked in warm water and soap or dishwashing liquid. • The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (10W ). Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the door open. Defrosting the appliance !Do not speed up the defrosting process by using any devices or tools, you may damage the refrigeration circuit. The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. [. . . ] • The outside ambient temperature is very high. • The appliance has not been installed on a level surface (see Installation). • The appliance has been installed between cabinets that vibrate and make noise. • The internal refrigerant makes a slight noise even when the compressor is off. [. . . ]