User manual BALTUR PRIMAVERA CA 25 S IONO SCHEMA

[. . . ] Pass them on to possible new owners of the appliance. Positioning and connection Positioning 1. Place the appliance in a well-ventilated humidity-free room. The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. [. . . ] Insert the plug into the socket and ensure that the internal light illuminates. Turn the TEMPERATURE ADJUSTMENT knob to an average value. After a few hours you will be able to put food in the refrigerator. Using the refrigerator to its full potential Use the TEMPERATURE ADJUSTMENT knob to adjust the temperature (see Description). Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). Remember that cooked foods do not last longer than raw foods. Do not store liquids in open containers. They will increase humidity in the refrigerator and cause condensation to form. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Height can be adjusted without complete removal of the shelf. GB 1 Setting the temperature The temperature inside the refrigerator compartment automatically adjusts itself according to the position of the thermostat knob. 1 = warmest 5 = coldest We recommend, however, a medium position. The cooling section of the refrigerator is located inside the back wall of the refrigerator compartment for increased space and improved aesthetics. Clean and dry the freezer compartment carefully before switching the appliance on again. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (10W or 15W). Avoiding mould and unpleasant odours The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Defrosting the appliance !Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. 1 2 6 Precautions and tips !The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. This appliance complies with the following Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03. 05. 89 (Electromagnetic Compatibility) and subsequent amendments; - 2002/96/CE. Disposal Observe local environmental standards when disposing packaging material for recycling purposes. The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. [. . . ] The thickness of the frost exceeds 2-3 mm (see Maintenance). The appliance has not been installed on a level surface (see Installation). The appliance has been installed between cabinets that vibrate and make noise. The internal refrigerant makes a slight noise even when the compressor is off. [. . . ]