User manual BANG & OLUFSEN BEOLAB 10

[. . . ] ­ The loudspeaker can only be switched off completely by disconnecting it from the wall socket. ­ Do not attempt to open the loud speaker. Leave such operations to qualified service personnel! ­ The loudspeaker is designed for indoor use in dry, domestic environments only, and for use within a temperature range of 10­40º C (50­105º F). [. . . ] The appropriate switch setting depends on the distance from the loudspeaker to the walls and corners of the room. The switch has two settings: W ­ Wall position This is the factory setting. Use this setting when the loudspeaker is F W placed so that the front is less than 50 cm (20") from the rear wall, for The POSITION switch is located on example when the loudspeaker is the loudspeaker socket panel. mounted on the wall bracket as explained in this Guide. F ­ Free-standing position This setting is for future use. To be used if the loudspeaker is placed so that the front is more than 50 cm (20") from the rear wall. Acoustic Lens Technology ­ manufactured under license from Sausalito Audio Works. 6 Set up the loudspeaker ­ wall bracket The wall bracket must be fastened to the wall so that the loudspeaker is placed in a centred position immediately below the television screen. We recommend that you place the television screen so that the loud speaker will be at least 10 cm (4") above the floor. 59 cm 23" 10 cm 4" About screws, washers and wall anchors Use the correct size and type of screws, washers and wall anchors ­ taking into account the construction and condition of the wall. Use at least four screws ­ two in each side of the wall bracket. Under each screw head use an appropriatly sized washer with a minimum thickness of 1. 6 mm (0. 07"). Each screw and washer must have a minimum load rating of 16 kg (35 lbs). Additional notice about light partition walls: If you intend to hang the loud speaker on a gypsum wall (also known as drywall or wallboard), the wall bracket must be fastened to a vertical stud!Mounting was evaluated for use on a drywall surface. Use one roundheaded lag screw (ø 6 mm ­ 0. 23"), which penetrates the gypsum and is screwed a minimum of 25 mm (1") into a vertical stud. Furthermore, use three additional screws of a type intended for gypsum walls. 7 To fasten the wall bracket 1 Fold the cardboard `tool' as shown, and attach it to the wall bracket. 2 Hold the wall bracket against the wall ­ centred below the tele vision screen. Make sure that the `tool' touches the screen edge. 3 Mark up on the wall where to drill the holes. [. . . ] NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]