User manual BANG & OLUFSEN BEOLINK 5000

[. . . ] ­ Do not place any items on the loudspeaker. ­ Do not lift the loudspeaker by gripping the acoustic lens. ­ Prolonged listening at high volume levels may cause hearing damage! Daily use 3 To clean the loudspeaker ! [. . . ] > Reconnect the loudspeaker to To switch on and off the mains supply. When you switch on your Bang & Should the problem persist, Olufsen system, the loudspeaker contact your Bang & Olufsen switches on simultaneously, and retailer. when you switch the system off again, the loudspeaker also switches to standby. When you have finished setting up the loudspeaker as described on the following pages, connect the entire system to the mains. 4 Set up the loudspeaker ­ cable connections The loudspeaker socket panel is located on the rear. Insert the cables and set the POSITION switch before you fasten the loudspeaker to the wall bracket. For information about the sockets on the Bang & Olufsen system, refer to the Guides enclosed with the product. Before you make any connections, disconnect your Bang & Olufsen system from the mains supply! POWER LINK socket Cable clamp POSITION switch Power Link Mk 3 POWER LINK socket: Use this socket to connect the loudspeaker to one of the Power Link sockets on the Bang & Olufsen system. Note: Do not use a Power Link cable of the older type, as this will cause noise, and therefore not give optimum sound quality!The new type has a triangular mark on the plug. Cable clamp: For safety reasons, the mains cord from the wall outlet must be secured to the loud speaker. To do so, tug the cord behind the cable clamp. Mains cord: The supplied mains cord and plug are specially designed for the product. The holes in the wall bracket allows for some adjustment. Make sure that the wall bracket is in the correct position ­ level and centred in the correct distance from the screen edge. 62 mm 2. 44" Cardboard `tool': The `tool' is used as a help to position the wall bracket in the correct distance from the lower edge of the television screen. >> Set up the loudspeaker ­ wall bracket To fasten the loudspeaker Attach the television screen and loudspeaker cables to the wall bracket before you fasten the loud speaker. ­ Connect the cables to the loud speaker and hang it on the wall bracket by inserting the three struts into the corresponding holes in the loudspeaker cabinet. ­ Adjust the loudspeaker position on the wall bracket. The correct position is obtained when the front of the loud¬speaker cabinet falls 13 mm (0. 51") `behind' the front of the television screen. ­ Tighten the screws at the end of all three struts ­ in order to lock the loudspeaker position onto the wall bracket. 13 mm 0. 51" 13 mm 0. 51" Loudspeaker position: The wall bracket allows you to adjust the loud speaker fronttoback position for use with different television screen sizes. For safety reasons, it is important that you lock the loudspeaker onto the wall bracket! To attach the loudspeaker front panel 1 Insert all the little pegs on the rear side of the panel into the corresponding holes in the loud speaker cabinet. 2 Make sure that all the pegs are firmly seated into the holes. When finished, the loudspeaker front panel must be aligned with the front of the television screen. [. . . ] Collecting electrical and For the Canadian market only!This class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations. This product is in conformity with the provisions of the Directives 1999/5/EC and 2006/95/EC. Technical specifications, features and the use thereof are subject to change without notice! For the US-market only! [. . . ]