User manual BANG & OLUFSEN BEOSOUND 8

[. . . ] The wall socket should always be easily accessible. Mount the rear feet on the BeoSound and make sure the front feet are mounted, unless you want to use the wall bracket. Place BeoSound 8 on a flat, stable surface, connect the power cable and dock your iPod®/iPhone®/iPadTM. Your iPod/iPhone/iPad is charged when connected. [. . . ] Pull out the cover at the bottom to release the locks, then lift it off. The approval labels are placed behind the back cover. AUX This means that AUX cannot be activated if an iPod/iPhone/iPad is connected, or other equipment is connected via USB Can also be used for connection to the AirPort Express to allow for wireless transmission of iTunes music to the BeoSound. For safety reasons fasten the mains lead behind the small peg, before running it out from the connection panel. Use this setting if the BeoSound is placed on a table or shelf not close to a wall. Use this setting is the BeoSound is placed close to the wall, for example mounted on the wall bracket. Replace the speaker cover > Remove the front foot. > Insert a small pin, such as a straightened paper clip in the hole under the front foot and push the speaker cover off. Prolonged listening at high volume levels may cause hearing damage. Avoid placing the product in direct sunlight or direct artificial light , such as a spotlight. ­ Make sure that the product is set up, placed and connected in accordance with the instructions. ­ Place your product on a firm surface or stand where you want it placed permanently. Use Bang & Olufsen approved stands and wall brackets only!­ Do not subject the product to high humidity, rain or sources of heat. ­ The product is developed for indoor use in dry, domestic environments only. use within a temperature range of 10­40°C (50­105°F). ­ Leave enough space around the product for adequate ventilation. ­ The product can only be switched off completely by disconnecting it from the wall socket. Cleaning Wipe dust off the surfaces using a dry, soft cloth. do not use liquid cleaners or aerosol cleaners. [. . . ] Can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ]