User manual BARKER & WILLIAMSON AT-110 TRAP ANTENNA
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BARKER & WILLIAMSON AT-110 TRAP ANTENNA. We hope that this BARKER & WILLIAMSON AT-110 TRAP ANTENNA user guide will be useful to you.
Lastmanuals help download the user guide BARKER & WILLIAMSON AT-110 TRAP ANTENNA.
Manual abstract: user guide BARKER & WILLIAMSON AT-110 TRAP ANTENNA
Detailed instructions for use are in the User's Guide.
[. . . ] BARKER & WILLIAMSON 603 CIDCO ROAD COCOA, FL 32926 321-639-1510
MODEL AT-110 ANTENNA 80, 40, 20, 15 and 10 Meter Bands Power Rating: 1000W PEP, 500W Output Length: 110 Feet
The Barker & Willamson Model AT-110 is a short dipole for the 80, 40, 20, 15 and 10 meter amateur bands. The 80 and 40 meter bands have a seperate trap (40 meters) which will give maximum efficiency and still be a short antenna for small lots and limited space. On 80 meters, the 40 meter traps work as loading coils, keeping the antenna short. [. . . ] It is imperative to follow the instructions step by step, in the order shown, to achieve satisfactory results with your antenna. (2) Remember that throughout the assembly procedure, wire lengths are always to be symmetrical on both sides of the antenna. Your traps may or may not have a color dot on one end of them. The wires must be cut approximately 2 - 3 feet longer than the dimensions shown in figure 1. This is to leave room for the hookups and tuning adjustments. Here are the lengths that you should cut (including the 2 - 3 ft extra). Cut two wires 36', and two wires 25' 6". Remember, you can always trim the wire shorter after tuning, but once cut too short . (4) Attach one end of the wire segments in the permanent manner shown in figure 2, working out from the center conductor. Allow roughly 6 to 8" of wire through the eyebolt before starting your wrap. Attach the 36' segments to both sides of the center connector. Attach the 25' 6" segments to one side of the TR40A traps. (5) Now assemble the sections of the antenna together paying attention to figures 1 and 3. The wire segment lengths shown are your starting point for tuning the antenna. Make sure that you make temporary connections as shown in figure 3. This will leave each wire segment with one end permanently soldered, and the other end temporarily connected for adjustment. [. . . ] Warranty is voided if product is subject to misuse, neglect, accident, improperly installed or used in violation of the instructions furnished by us. We reserve the right to make changes in design at any time without obligation to update previously manufactured models. This warranty is given in lieu of any other warranty, expressed or implied. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE BARKER & WILLIAMSON AT-110 TRAP ANTENNA
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual BARKER & WILLIAMSON AT-110 TRAP ANTENNA will begin.
