User manual BARNETT CROSSBOWS QUAD 400 CRANK COCKING DEVICE

[. . . ] If this clicking sound is not present, place the safety in the engaged position. UN-COCKING THE CROSSBOW - DO NOT un-cock the crossbow with the Crank Cocking Device. This could cause bodily injury or damage to your crossbow. [. . . ] Carefully package and return, transportation prepaid to: Barnett International, Inc. Attn: Service Department 13447 Byrd Drive Odessa, FL 33556 THIS PAGE INTENTIONALLY LEFT BLANK CRANK ASSEMBLY STEP 1 NOTE: ANCHORS WILL GO OVER STRING FROM SPOOLS TO CONTAIN THEM IN THE GROOVE 2. RIGHT SIDE STRING SPOOL (THE SPOOL WITH NOTCHES) 4. LEFT SIDE STRING SPOOL Insert 1/8" pins (5) into right side string spool, then insert right side string spool into middle stock hole. (Note: You may apply a white lithium grease to the spool bushing to reduce friction. ) Insert left side string spool (1) into middle stock hole. It is important to keep the string spools position the same way on either side to allow even take up of string during use (see note below). Once spools are connected, insert the 1/4-20 X. 5/8" (4) socket head cap screw into right side string spool (2) and thread into left side string spool (1). To tighten, align crank handle (6) with left side string spool (1) and thread in thumb screw (3). Using supplied allen wrench tighten 1/4-20 x 5/8" socket head cap screw (4). NOTE: BE SURE THE STRING IS AT EQUAL LENGTHS AND THE KNOT HOLE ON BOTH RIGHT AND LEFT STRING SPOOLS ARE IN LINE WITH EACH OTHER WHEN CONNECTING THEM TOGETHER (#'s 1 & 2). CRANK ASSEMBLY STEP 2 STRING 7. #10 -24X1" SOCKET HEAD CAP SCREW Insert right side string anchor (7) into front stock hole. Insert left side string anchor (8) into front stock hole. Insert #10-24X1" socket head cap screw (11) into left string anchor and tighten. Press Finish Caps (9 & 10) into right and left anchor holes. CRANK ASSEMBLY STEP 3 CONNECT STRING PULLER ASSEMBLY USING DOVETAIL UNDER FRONT OF SCOPE MOUNT WHEN NOT IN USE. 15. CATCH PLATE Insert spool catch (12) into the right side back hole. Insert catch plate (13) into left side back hole. Insert #440 socket head cap screws (14) through catch plate and thread into spool catch. Press catch cover (15) into hole when completed. WARNING: NEVER USE YOUR CRANK DEVICE TO UN-COCK/ UN-LOAD STRING FROM TRIGGER CRANK OPERATION NOTE: TO DISENGAGE THE RATCHET FEATURE PLACE TOGGLE SWITCH INTO THE BACK AND DOWN POSITION. [. . . ] While holding the Crank Handle securely, place the Toggle Switch into the back and down position. Turn Crank Handle slowly counter clockwise until the trigger mechanism stops the crossbows string. Place String Puller Assembly on bottom dovetail of scope mount to keep out of the way when shooting. BARNETT INTERNATIONAL INC. [. . . ]