User manual BARNETT CROSSBOWS RHINO SPORT MAGNUM

[. . . ] RHINO SPORT MAG Manual Includes the Following: Safety Guidelines Assembly Guides Trouble Shooting General Information Warranty Information Care and Maintenance finest crossbow in the world. Congratulations!You are now the proud owner of the Please follow all safety, assembly and trouble shooting instructions contained in the manual. It is extremely important to read and follow the instructions before attempting to use your crossbow. Serious injuries to yourself or others, damage to your crossbow or poor performance from your crossbow could result from failure to thoroughly read and understand these instructions. [. . . ] Slowly release hand pressure on the string until you are sure it is locked securely into the trigger mechanism. The crossbow is now cocked with the safety on. Note: The serving on the string has had a line on each side of the flight surface marked at the factory. After cocking the crossbow make sure that the marks on the string are showing equally on each side of the trigger mechanism. Unevenly cocked crossbows will have erratic arrow flight. When restringing your crossbow mark the serving of the string, on each side of the flight track at rest. Apply Barnett Lubewax to the string serving and track surface. Loading your Crossbow 1. ) Place the arrow forward under the front sight bracket and lay the arrow on the flight surface. When using arrows with moon nocks, be sure that the odd colored fletch is placed in the flight grove and that the concaved nock is parallel to the string. 2. ) Slide the arrow back under the arrow retaining spring and fully into the trigger mechanism. Note: The arrow retaining spring should only exert enough pressure to hold the arrow in place without lifting it from its position on the flight surface. Note: If arrows with moon nocks are used, be sure that the odd colored fletch is placed in the flight grove and that the concaved nock is parallel to the string. 8 Firing your Crossbow To fire the arrow from your crossbow, the safety must be released. The safety release button is located on the rear side of the trigger shroud. Point the crossbow in a safe direction and slide the button forward. Turn the safety switch to the off position. The crossbow will now fire when the trigger is pulled. The safety MUST be disengaged in this manner prior to every shot. BE SURE TO KEEP YOUR FINGERS BELOW THE FLIGHT TRACK WHILE SHOOTING. See photos following for correct positioning. CORRECT INCORRECT CORRECT INCORRECT This will prevent your hands from being struck by the string as it travels forward. The velocity of the string hitting your fingers will cause severe injury. Unloading your Crossbow By far, the safest and only recommended way to un-cock a loaded crossbow is to fire it into a target or into the ground away from debris, loose rocks or other people. Sighting-In the Crossbow Using the rear peep sight and front sight pins: 1. ) Place the first sight pin near the top of the front sight bracket. 9 2. ) Shooting at a target from 10 yards, aim for the bulls eye. If the first shot is above the bullseye, move the pin up (or down if the shot is below the bulls eye). [. . . ] PRIOR TO EVERY SHOOTING SESSION, IT IS RECOMMENDED THAT A COMPLETE CHECK OF STRING, CABLES, WHEELS, SCREWS AND ARROWS BE MADE. · · · Always store your crossbow in a safe, dry place. Do not expose your crossbow to extreme heat, such as closed, hot vehicles or near heat sources. Inspect cables and strings for signs of wear. [. . . ]