User manual BARRACUDA SPAM VIRUS FIREWALL OUTBOUND 3.5.X QUICK START GUIDE

[. . . ] If you do not have a monitor and keyboard and want to set the IP using the RESET button on the front panel, press and hold the RESET button per the following table: IP address 192. 168. 200. 200 192. 168. 1. 200 10. 1. 1. 200 Press and hold RESET for. . . 5 seconds 8 seconds 12 seconds Opening Firewall Ports If your Barracuda Spam & Virus Firewall is located behind a corporate firewall, open the following ports on your firewall to ensure proper operation. Port 25 53 80 123 Direction In/Out Out Out In/Out TCP Yes Yes Yes No UDP No Yes No Yes Usage Email and email bounces Domain Name Service (DNS) Virus, firmware and spam rule updates** Network Time Protocol (NTP) Physical Installation To install the Barracuda Spam & Virus Firewall: 1. Fasten the Barracuda Spam & Virus Firewall to a 19-inch rack or place it in a stable location. Connect an Ethernet Cable from your network switch to the ethernet port on the back of the Barracuda Spam & Virus Firewall. [. . . ] Click any one of the Save Changes buttons to save all of the information. Click OK to acknowledge the download duration message. To avoid damaging the Barracuda, do not power OFF during an update or download. To view download progress, refresh your browser. You will be notified when the download is complete. On the AdvancedFirmware Update page, click the Apply Now button to apply the firmware. This will take a few minutes to complete. After applying the firmware, Barracuda Networks recommends logging in to the Web interface again and reading the Release Notes to learn about enhancements and new features. It is also good practice to verify settings, as new features may have been included with the firmware update. Change the Administrator Password To avoid unauthorized use, we recommend you change the default administrator password to a more secure password. You can only change the administrator password for the Web interface. You cannot change the password for the Administrative Console, but this is only accessible via the keyboard which you can disconnect at any time. Go to BasicAdministration and enter your old and new passwords. Product Activation Verify that the Energize Updates feature is activated on your Barracuda by going to the BasicStatus page. Under Subscription Status, make sure the Energize Updates subscription is Current. If the Energize Updates is Not Activated, click the corresponding activation link to go to the Barracuda Networks Product Activation page and complete activation of your subscriptions. Convert to Outbound Outbound ensures all email leaving your network is virus-free and legitimate. Go to Basic Administration scroll to Operation Mode section. Click Convert, a warning message will appear to confirm. Click Yes, system will reboot after complete conversion. [. . . ] On the General tab, choose Forward all mail through this connector to the following smart hosts. Put the IP address of the Barracuda Spam & Virus Firewall Outbound in square brackets, for example: [10. 0. 0. 1]. This will relay all emails to the Barracuda Spam & Virus Firewall Outbound. Be sure to check out the Barracuda Networks Support Forum at: http://forum. barracuda. com for Frequently Asked Questions (FAQs) and other helpful tips for setting up and using your Barracuda Spam & Virus Firewall. For additional documentation including an Administrator's Guide, visit http://www. barracuda. com/documentation. Contact and Copyright Information Barracuda Networks, Inc. [. . . ]