User manual BARTSCHER 1 BECKEN 16L SCHEMA

[. . . ] · Warnings and Important Safety Instructions in this manual do not cover all possible conditions and situations that may occur. It is your responsibility to use common sense, caution, and care when installing, maintaining, and operating your appliance. · Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual and not all warning signs may be applicable. If you have any questions or concerns, contact your nearest service center or find help and information online at www. [. . . ] In order for the ice maker to operate properly, a water pressure of 20~125 psi (pound per square inch) is required. Under normal conditions, a 170 cc (5. 75 oz. ) paper cup can be filled in 10 seconds. If the Refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. Water line installation kits are available at extra cost from your dealer. We recommend using a water supply kit that contains copper tubing. Fridge Leg Screwdriver(-) Refer to the next section for the best way to make very minor adjustments to the doors. MAKING MINOR ADJUSTMENTS TO THE DOORS Remember, a level refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on levelling the refrigerator. When the door of the fridge is higher than the freezer Insert a flat-blade screwdriver into a slot on the freezer leg, then turn it clockwise. Check the accessory list below. Water line fixer and screws Pipe connector Water line Clip When the door of the freezer is higher 10_ setting up Connecting to the water supply line 1. First, shut off the main water supply line. Locate the nearest cold, drinking water line. Follow the Water Line Installation Instructions in the installation kit. If you have to repair or disassemble the water line, cut off 6. 5mm of the plastic tubing to make sure you get a snug, leak-free connection. CAUTION Before being used, the leakage in these places should be examined CAUTION The water line must be connected to the cold water pipe. Push the bucket in firmly until you hear a clicking sound. If the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in Figure 2. Figure 2 A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation. Before calling service Any sounds you hear when the ice maker dumps ice into the bucket are part of normal operation. Ice Chute If you don't dispense ice for a Figure 3 long period of time, the ice may form clumps in the ice bucket. If ice clumps form, remove the remaining ice and empty the bucket. When ice does not come out, check for ice stuck in the chute and remove it. - When Ice Off blinks on the display panel, reinsert the bucket and/or make sure it's installed properly. When the door is open, the Ice and water dispenser do not work. If you close the door hard, it may cause water spilling over the ice maker. To prevent dropping the ice bucket, use both hands when removing it. [. . . ] This is normal and occurs because various accessories are contracting or expanding in relation to the temperature of the refrigerator interior. Some heat is normal as anti-condensators are installed in the front corners of the refrigerator to prevent condensation. Condensation can occur when you leave the door open for a long time. Did you wait at least 12 hours after installation of the water supply line before making ice? [. . . ]