User manual BARTSCHER 100058-229

[. . . ] Push cylinder into connector to compress ball valve while rotating cylinder counterclockwise. Rotate cylinder to release pins from slots on connector. Remove discharge tube body from piston by rotating discharge tube body counterclockwise. Be prepared for ball valve to fall loose when removing discharge tube body from piston. [. . . ] Be prepared for ball valve to fall loose when removing discharge tube body from piston. Remove locking collar and gaging collar(s), if used, from piston by sliding them off. Remove seal from end of piston by rotating and pulling off of lip on piston. Remove knob from discharge tube body by pulling knob at an angle until knob flanges release from lip on discharge tube body. Remove discharge fitting from discharge tube by releasing fitting loop and pulling fitting away from discharge tube. Before first use and after use daily, disassemble and clean pump. It is important to clean, rinse, sanitize, and dry these parts daily and properly. Failure to comply with any of these instructions may void unit warranty: 1. flush and rinse pump in a container of warm water. Place lower end of pump into water container and operate pump until all (if any) remaining product is expelled and only the warm water flows from the discharge tube. Rotate discharge tube body clockwise until secure with pump tube assembly. Install the other ball valve with the ball side seated down into opening inside connector. Install bottom end of pump body, with pins, into connector with ball valve in position resting inside connector. Compress ball valve slightly and rotate pump body into connector until pins secure into slots in connector. Install lid onto pump body by aligning large hole in lid to rest on threaded lip of pump body assembly. Install plunger assembly into pump body assembly. Compress pump and rotate until flats on piston align into position with flats inside cylinder. While compressing pump, rotate locking collar clockwise to secure onto threading of cylinder. The suction tube may be cut with scissors to the needed length. After cleaning pump and during pump assembly, determine the amount of product you would like to be dispensed with each full stroke of the pump. [. . . ] While compressing pump, rotate locking collar clockwise to secure onto threading of cylinder. The suction tube may be cut with scissors to the needed length. After cleaning pump and during pump assembly, determine the amount of product you would like to be dispensed with each full stroke of the pump. Gaging collars are included with the pump to allow you to change the portion control. [. . . ]