User manual BARTSCHER 101.560 SCHEMA

[. . . ] · Refrigerant squirting out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any naked flames or potential sources of ignition and air the room in which the appliance is standing for several minutes. · In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit occurs, the size of the room in which the appliance may be sited depends on the amount of refrigerant used. Never start up an appliance showing any signs of damage. [. . . ] After adjusting the doors, turn the nut 1 clockwise until it reaches the lower end of the bolt, then tighten the bolt again with the wrench place 1 . 3 1 Wrench 2 nut Bolt 3 to fix the nut in If you do not secure the nut firmly, the bolt may release. 10_ setting up CHECKinG THE WaTEr DisPEnsEr LinE (oPTionaL) A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup can be filled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. Water Line installation Kits are included. Insert water supply tube into the inlet side of the filter until the tube stop. fLoW DirECTion Attachthepurifierlock-clip. - Hold the purifier lock-clip in the appropriate position (under the sink for example) and fix it tightly into place where to screw. WaTEr sUPPLy inLET siDE PErMEaT Purifier lock-clip Note: You must also ensure that the cut is square and not at any sort of angle as this could cause a leak 4. After inserting tube, put together the clip strongly. The Clip fix the tube. Securethepurifierinposition. - Fix the purifier in position, as shown in the figure on the right. WaTEr TUBE PUrifiEr LoCK-CLiP 5. If leaks persist, discontinue use and call your supporting dealer. Flush filter for 5 minutes before use. PUrifiEr setting up _13 Connectthewaterlinetothe refrigerator. - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. - When connected, check if there is any leakage. - Reattach the compressor cover of the refrigerator. WaTEr LinE ConnECTion nUT Checktheamountofwatersupplied totheicetray. 1. Lift up the icemaker cover and gently pull out. When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below). [. . . ] Some heat is normal as anti-condensators are installed in the front corners of the refrigerator to prevent condensation. Condensation can occur when you leave the door open for a long time. Did you wait for 12 hours after installation of the water supply line before making ice?Is the water line connected and the shut-off valve open? [. . . ]