User manual BARTSCHER 101.580 DATASHEET

[. . . ] Always make sure the media setting matches the print media you are using. If you have a System Administrator, only they can reset the defaults. Press the down arrow key to move down to Admin Setup. Press the up arrow key (a to z, 0 to 9) or the down arrow key (9 to 0, z to a) to scan through the various numbers and letters of the alphabet. [. . . ] Press the down arrow key to move down to Settings. Temporarily Changing the Media Weight for an Individual Print Job If you are printing a job on special media, you can temporarily load the media in a tray and change the media settings for that tray in the driver as you print the job. Media Weight Settings Media weight settings can be made in the printer menu or the printer driver. 5 x 14'' (216 x 356 mm) Must be defined in driver before printing: see your on-line User's Guide. Adjust the paper size dial to the size of the paper being used. Must be defined in driver before printing: see your online User's Guide. Load face up, top edge into the printer. envelopes · Load print side up (flap down) with top edge aimed into the printer. Provides straight-through, curl-free print path for transparencies, envelopes, labels and heavy paper. Sheets exit face up (for multi-page documents, select reverse order printing in your application Print dialog box). Lower cover, but do not latch If a sheet is well advanced out of the top of the printer, grip it and pull gently to draw it fully out. Do not touch the green image drum surface or expose it to light for more than 5 minutes. Cover them to protect Entering the fuser, separate the trailing edge of the sheet from the belt, pull the fuser pressure release lever (1) towards the front and remove the sheet. Press release lever (1) and pull the trapped paper from the fuser. Replace the fuser unit and push the lock levers toward the rear of the printer. If the sheet is well advanced into the fuser: a. Push the two retaining levers (1) towards the front of the printer to release the fuser. \Replace the image drums/toners, being careful to install them in the proper sequence. Open the rear exit tray and pull out any sheets found in this area. Open the duplex unit cover and remove any sheets. [. . . ] Open the duplex unit cover and remove any sheets. Lower the printer cover to Protect the image drums from light, but do not latch it. Lift the front cover release Pull out the paper tray and Close the front cover. Press down on the printer For printers equipped with the optional second paper tray: Pull out the second paper tray and remove any jammed paper. [. . . ]