User manual BARTSCHER 103.065

[. . . ] Keep this instruction manual ready to hand at the product!This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. In addition to the information given here, you should comply with any local Health and safety Controls and generally applicable safety regulations. [. . . ] Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. ON/OFF switch with control light Stainless steel casing; two chambers for plates with a platform for stacking; each chamber has 4 adjustable leads to set the platforms at desired heights; the chamber suspension system is adjustable and can support various weights; plates are always ready for use; when one is removed, it is replaced at the top by the next one; each chamber can hold around 50 plates, depending on the thickness of each plate; the rolling plate dispenser is equipped with a heating system and ventilator, which ensures quick and even heating of the plates; the safety shield under the platform prevents direct contact between the plates and heating element. The device must only be connected to a properly installed single socket with protective contact. Never yank cord to disconnect from outlet. See that the cable does not touch any heat sources or sharp edges. During operation some elements of the device very become hot. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. Do not lay the cable over carpets or heat insulations. Keep away the cable from operating range and do not dunk it into water. Do not move or tilt the device when in operation. Before installation the local power grid specification should be compared with that of the device (see type label). connect the device only in case of compliance!Place the device on a flat, secure surface that can support the device's weight and is resistant to high temperatures. never place the device on a flammable surface. Never leave the device near an open flame, electric furnace, coal furnace or any other sources of heat. The device can be used in ambient temperatures up to 32° at normal humidity. C Do not leave the device in the vicinity of any steam-producing equipment. Always secure the device using the brake. Failure to secure the device can cause it to move unexpectedly and may result in injuries or damage to the device. [. . . ] Therefore, you must not use any kind of pressure water jet for cleaning the device!O Prior to washing, remove plates from the device and leave the device to cool. O Wash the platforms, leads and surface of the device with a soft cloth and gentle cleaning fluid. O Rinse with clean water to remove any remaining cleaning fluid. [. . . ]