User manual BARTSCHER 103.069

[. . . ] This symbol highlights instructions, which should be followed to avoid any risk of damage, malfunctioning and/or breakdown of the device. This symbol highlights tips and information, which have to be followed for an efficient and trouble-free operation of the device. This symbol is a warning that the unit surface is hot when in use. Ignoring this warning may result in burns! [. . . ] Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. Stainless steel, with fixed intermediate shelf 230 V ~ 50 Hz 30° - 80° C about 30-40 plates, up to Ø 320 mm Ø 460 mm, H 575 mm Ø 330 mm (usable), Internal height. The device must only be connected to a properly installed single socket with protective contact. Never yank cord to disconnect from outlet. See that the cable does not touch any heat sources or sharp edges. During operation some elements of the unit very become hot. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. Do not lay the cable over carpets or heat insulations. Keep away the cable from operating range and do not dunk it into water. Do not move or tilt the device when in operation. Before installation the local power grid specification should be compared with that of the device (see type label). [. . . ] Casing, shelves for plates, and rotating glass door should be cleaned with a soft, moist cloth and mild cleaning agent. Only use a soft cloth and make sure you never use any kind of abrasive agents or pads which could scratch the surface. After the cleaning procedure, you should use a soft and dry cloth to wipe dry and polish the surface. Make sure the device has been cleaned properly before storing it in a dry place. [. . . ]