User manual BARTSCHER 106.788 SCHEMA

[. . . ] The wide freezer drawer also provides enough space for 2~3 turkeys. · SecureAutoClose The Secure Auto Close feature will automatically close a door that is slightly open. · DigitalDisplayandTemperatureControl · DoorAlarm A helpful beeper alerts you if a door is ajar. CENotice This product has been determined to be in compliance with the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC) and the Eco-Design Directive(2009/125/EC) implemented by Regulation (EC) No 643/2009 of the European Union. For easy future reference, write the model and serial number down. You will find your model number and serial number on the left side of the refrigerator. Model # Serial # 02_ features safety information SAFETY INFORMATION · Before operating the appliance, please read this manual thoroughly and retain it at a safe place near the appliance for your future reference. · Use this appliance only for its intended purpose as described in this instruction manual. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] · Reattach the door/drawer properly to avoid: - Moisture from air leakage. - Wasting energy due to improper door seal. 14_ setting up setting up your refrigerator dISASSEMblING ThE FRIdGE dOOR Be careful not to drop and scratch the fridge door while removing the fridge door! WARNING 01 SETTING Up Socket wrench Top Table 1. Remove the 3 screws holding down the top table and remove it. 2. Disconnect electric wire on the top of the refrigerator. 3. Remove the 3 hex bolts that hold the hinge on the top of the refrigerator with the 10mm socket wrench. 4. Remove the screw that holds the ground wire with a philips screwdriver(+). 5. Separate the hinge from the electric wire and ground wire as shown above. 6. Be careful not to drop and scratch the doors while removing them. dISASSEMblING ThE FREEzER dOOR (dRAWER TYpE) Middle hinge 1. Separate the cap on the middle hinge. 2. Remove the screw attached to the left and right middle hinges with a philips screwdriver(+). Remove the 2 hex head bolts attached to the left and right middle hinges with an allen wrench(Ø5mm). setting up _15 3. Replace the drawer box. REASSEMblING ThE FREEzER dOOR (SWING TYpE) 1. Place the hole in the bottom of the freezer door over the right side low hinge. 2. Replace the middle hinge connected to the freezer. Insert and tighten the screw into the left and right middle hinges with a philips screwdriver(+). Insert and tighten the 2 hex head bolts into the left and right middle hinges with an allen wrench(Ø5mm). Replace the cap on the middle hinge. 18_ setting up setting up your refrigerator hOW TO REvERSE ThE dOOR (OpTION) Unplug the refrigerator or disconnect the power. Disassemble ground wire by removing 1 screw on each side. 5. Disassemble the upper hinge by removing 3 bolts on each side with the 10mm wrench. 1. Fridge door is possible to tip over at this time. 6. Remove each fridge doors by lifting it up. 1. Possible to drop or scratch the door at this time. [. . . ] · Is the temperature in the room too low?· Did you store the food too close to the air vent at the back of the refrigerator?· Check that the refrigerator is level and stable. · Is the back of the refrigerator too close to the wall and therefore keeping air from circulating? [. . . ]