User manual BARTSCHER 106777 CONTROL PLAN

[. . . ] Press + repeatedly until the second line of the display shows the Value (Light, Medium, or Heavy [see page 15]) you wish to use. Double-sided Face down Top edge away from the printer. Envelopes: If you are setting the MP Tray for envelopes, press ON LINE and you are done. Heavy paper / labels: If you are setting the MP Tray for heavy paper or labels, keep going. [. . . ] The second line of the display starts blinking. Press + repeatedly until your choice of CARD STOCK or LABELS appears on the second line of the display. The setting is engaged and the second line of the display stops blinking. Provides straight-through, curl-free print path for transparencies, envelopes, labels and heavy paper. Sheets exit face up (for multi-page documents, select reverse order printing in your application Print dialog box). How to Print a File Using the Duplexer Open the file you wish to print and click File Print. Note If you experience curling with 20 or 24 lb. Always make sure the media setting matches the print media you are using. Temporarily Change the Media Weight for an Individual Print Job If you are printing a job on special media, you can temporarily load the media in a tray and change the media settings for that tray in the driver as you print the job. Printer Driver Versus Printer Menu Print media settings can be made in the printer driver or in the printer menu. Ranges for Weight Media weight settings can be made in the printer menu or the printer driver. If there is a paper size mismatch error, press ON LINE to force the job to print. When the printer is in the Menu mode, press CANCEL to exit the Menu mode and place the printer back on line. The fuser behind the cyan (C) toner may be HOT. Do not expose the drums to light for more than 5 minutes. Do not touch the shiny green area on the bottom. If the sheet does not come out easily, continue. If the sheet does come out easily, close the cover. Push the XXX Toner lock lever toward the back of the printer as far as it will go. If this does not clear the message, call your local service dealer. xXX ORDER TONER Note If you have changed the LOW TONER setting to STOP, the ATTENTION light will blink and you must either replace the toner cartridge immediately or press the ON LINE button to continue printing. When this message appears, the printer stops after every 20 pages. [. . . ] To continue printing, you must open and close the top cover. (See the instructions supplied with the new image drum. Reduce the size of the file being printed (e. Install additional memory in the printer (see your on-line User's Guide for more information). [. . . ]