User manual BARTSCHER 106889 CONTROL PLAN

[. . . ] Sheets exit face up (for multi-page documents, select reverse order printing in your application Print dialog box). Note If you experience curling with 20 or 24 lb. Always make sure the media setting matches the print media you are using. Print media settings can be made in the printer driver or in the printer menu. [. . . ] Press + repeatedly until your choice of CARD STOCK or LABELS appears on the second line of the display. The setting is engaged and the second line of the display stops blinking. The second line of the display starts blinking. Press Press + repeatedly until the second line of the display shows the Value (for envelopes, select COM-10 ENVELOPE) you wish to use. Print media must be able to withstand 446°F (230°C) for 0. If you wil be printing banners, it is recommended that you purchase and install the optional 64 MB DIMM (Oki 70057501). Make the following settings in the printer driver as you print the job: · Make the following settings in the printer driver as you print the job: · Print media must be able to withstand 446°F (230°C) for 0. Never use envelopes with metal clasps, snaps, windows, or V-flap seals: Make the following settings in the printer driver as you print the job: · Make the following settings in the printer driver as you print the job: · Size = see sizes above Power Save sets how long the printer waits before going into standby mode. This saves energy, but the printer requires time to warm up when it receives a print job or if you want to enter the menu and change settings. The second line of the display starts blinking. Press + to toggle back and forth between DISABLE and ENBABLE. If the sheet does not come out easily, go to step 3. If the sheet does come out easily, close the cover. Appears on the second line of the display to indicate that the item specified will soon need to be replaced. Note If you have changed the LOW TONER item in the SYSTEM CONFIG MENU to STOP, the ATTENTION light will blink and you must either replace the toner cartridge immediately or press the ON LINE button to continue printing. What to Do Be sure you have a genuine BARTSCHER replacement toner cartridge or image drum on hand (see page 6). When this message appears, the printer stops after every 20 pages. To continue printing, you must open and close the top cover. When this message appears, the printer stops after every 20 pages. To continue printing, you must open and close the top cover. What to Do Remove the toner cartridge and replace it with a genuine BARTSCHER Toner Cartridge (see page 6). What to Do Replace the toner with a genuine BARTSCHER Toner Cartridge (see page 6). [. . . ] Note If the message still appears, push the blue latches at either end of the fuser back (toward the printer cover hinge) and lift the fuser out, then lower it back into the printer, pushing it firmly down in place. You should feel the latches at either end engage. The printer has received a job for printing from the Multi-Purpose Tray and no media is loaded in the tray. What to Do Load the requested media (xxx) in the Multi-Purpose Tray, then press ON LINE. [. . . ]