User manual BARTSCHER 1250403

[. . . ] In this manual, symbols are used to highlight important safety instructions and any advice relating to the device. The instructions should be followed very carefully to avoid any risk of accident, personal injury or material damage. This symbol highlights hazards, which could lead to injury. Please follow the instructions very carefully and proceed with particular attention in these cases. [. . . ] Any use going beyond the intended purpose and/or any different use of the device is forbidden and is not considered as conventional. Any claims against the manufacturer or his authorized representative as a consequence of experiencing damages resulting from unconventional use are impossible. Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. The electrical circuit in the socket must be secured to at least 16A. Only connect the unit directly to the wall socket; do not use any extension cords or power strips. Place the unit so that the plug is easily accessible and can be quickly removed from its socket in case of necessity. There is a ground pin on the back of the device. Please connect the earth cable with a copper cable (diameter at least 2 mm²) in conformity with the valid general safety regulations. A green network connection indicator light is on. After turning the device on, it need approx. 10 minutes to reach the temperature of 250°C. When the device reaches the desired temperature, the red temperature indicator light turns off. if the temperature falls down for about. 10°C, the heating is turned on again and the red temperature indicator light turns on. [. . . ] Never use any aggressive cleaning agents or sprays. Clean the casing, the handle and the outside of the top grill with a damp cloth. Use a mild detergent in case the device is really dirty. wipe the grill plates grooved on the inside with warm water and a damp cloth. [. . . ]