User manual BARTSCHER 1315213

[. . . ] In this manual, symbols are used to highlight important safety instructions and any advice relating to the device. The instructions should be followed very carefully to avoid any risk of accident, personal injury or material damage. This symbol highlights hazards, which could lead to injury. Please follow the instructions very carefully and proceed with particular attention in these cases. [. . . ] Safe operation is only guaranteed when using the device for its intended purpose. Any technical interventions, as well as assembly and maintenance are to be made by a qualified customer service only. The ice cube maker "Compact Ice II" may only be used to make ice cubes. Any use going beyond the intended purpose and/or any different use of the device is forbidden and is not considered as conventional. Any claims against the manufacturer or his authorized representative as a consequence of experiencing damages resulting from unconventional use are impossible. Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. Make sure that there is at least 15 cm distance between the back and the sides of the device and the wall. The electrical circuit in the socket must be secured to at least 16A. Only connect the unit directly to the wall socket; do not use any extension cords or power strips. If the ice cube maker is kept outside during the winter and then taken inside for use, please let it warm up to room temperature before plugging it in. Wipe down the outside and the inside of the device with a soft cloth and the ice cube basket and clean it. Position the device in a way so that the plug is easily accessible. Select the required ice cube size by pressing the , , Select" button. If the room temperature is above 16° we advise selecting the , , S - small" or , , M - medium" to avoid the ice cubes sticking C, together. Open the lid; remove the ice container and pour water into the container (tank) to just below the mark. Press the , , Power" button on the control panel to start the ice cube making process. Depending on the selected size, the ice cube making process takes between 6 and 12 minutes. [. . . ] Do not use any petrol products to not damage the plastic parts and the operating panel. O o After the cleaning procedure you should use a soft and dry cloth to wipe dry and polish the surface. O When the device is not in use, open the water drainage cap to empty the water container completely. O Make sure the device has been cleaned and dried properly for further usage. [. . . ]