User manual BARTSCHER 150309

[. . . ] In this manual, symbols are used to highlight important safety instructions and any advice relating to the device. The instructions should be followed very carefully to avoid any risk of accident, personal injury or material damage. This symbol highlights hazards, which could lead to injury. Please follow the instructions very carefully and proceed with particular attention in these cases. [. . . ] Any technical interventions, as well as assembly and maintenance are to be made by a qualified customer service only. The hot water dispenser is intended only for boiling water and keeping it at high temperatures: Do not use the hot water dispenser for: heating or boiling liquids containing sugar, sweeteners, acids, alkalines or alcohol; storage and heating of fluids or materials which are flammable, dangerous to health, etc. Any use going beyond the intended purpose and/or any different use of the device is forbidden and is not considered as conventional. Any claims against the manufacturer or his authorized representative as a consequence of experiencing damages resulting from unconventional use are impossible. Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Prior to first use, wash the unit with warm water and a mild cleaning agent. Rinse with clean water and dry thoroughly. Fill the reservoir with the desired amount of fresh water (up to the marking , , MAX"). To reduce the time needed for heating, fill the reservoir with warm water. Fill with only the necessary amount of water!Too much water in the reservoir may result in spilling and burns!Place the lid on the reservoir using the lock, and turn the reservoir clockwise to close. connect the unit to an appropriate outlet. It is important that water be in the unit prior to turning it on. Do not will the reservoir with other liquids which cannot be consumed, such as acids, alkalines, oils, etc. Set the desired temperature using the temperature dial between 30°C and 100°C. [. . . ] After it cools, descale the unit (see 6. After descaling, the unit can be turned on again. O Before beginning with repair or cleaning works make sure the device has been disconnected from power socket (pull the power plug!O Do not use any acid agents and make sure no water ingresses the device. [. . . ]