User manual BARTSCHER 200233

[. . . ] We recommend that you read the instructions in this owner’s manual carefully before use for the best performance and to extend the life of your appliance, as it will provide you with all the instructions you require to ensure its safe installation, use and maintenance. Always keep this owner’s manual close to hand since you may need to refer to it in the future. Control Panel Cooking mode selection knob Cooking temperature selection knob Electronic programmer Dripping Pan or Baking Sheet Oven Rack Guides for sliding the racks or dripping pan in and out 1. Date / clock / end cooking time setting Control panel lock / timer / cooking time setting Language setting Start cooking / Stop cooking / oven light / display brightness 5. [. . . ] Please remember that the time entered does not include the necessary pre-heating stage. € set the end cooking time by pressing button 1. The display panel will feature the end cooking time obtained by adding the current time to the previously selected cooking time, as well as the time necessary for the oven to preheat (automatically calculated by the appliance according to the cooking mode selected). Turn knob “C” until the display panel features the time you want the food to be ready. After these selection procedures, the display panel will feature the time at which preheating will commence (where foreseen), and that at which cooking will be over. The latter can be altered up until the cooking mode and temperature reappear on the display panel. Any incorrect data can be corrected simply by repeating the above-stated instructions. • press button 4 to activate the programming. To modify the settings made, press button 4 for approximately 3 seconds and repeat the above procedures. per annullare una cottura già programmata To cancel a cooking schedule already programmed. To cancel any programme which has been entered, turn knob “B” anticlockwise until the word “OFF” appears on the display panel. Some examples are included in the “Practical Cooking Advice” table. When cooking other food on several racks, use the “Multi-cooking” mode, keeping the following suggestions in mind: • The oven is fitted with 5 racks. During fan assisted cooking, use two of the three central racks; the lowest and highest racks receive the hot air directly and therefore delicate foodstuffs could be burnt on these racks. € As a general rule, use the 2nd and 4th rack from the bottom, placing the foodstuffs that require greater heat on the 2nd rack from the bottom. For example, when cooking meat roasts together with other food, place the roast on the 2nd rack from the bottom and the more delicate food on the 4th rack from the bottom. € When cooking food that requires differing times and temperatures, set a temperature that is somewhere between the two temperatures required, place the more delicate food on the 4th rack from the bottom and take the food requiring less time out of the oven first. € Use the dripping pan on the lower rack and the grid on the upper; Using the “Fast Cooking” Mode Functional, fast and practical for those of you who use pre-packed products (such as for example: frozen or precooked food) along with other food items. You will find useful suggestions in the “Practical Cooking Advice” table. Using the Grill The “7 Cuochi” oven offers you several different grilling modes. after cleaning , it is advisable to rinse thoroughly and dry. To catch any fat and/or grease that may drip from the rack, place the dripping pan provided on the first rack from the bottom. [. . . ] The wire for earthing the appliance is yellow-green in colour. Fitting on a Power Supply Cable Opening the terminal board: • Using a screwdriver, prise on the side tabs of the terminal board cover; • Pull open the cover of the terminal board. To install the cable, proceed as follows: • Remove the wire clamp screw and the three contact screws L-N-6 • Fasten the wires beneath the screwheads using the following colour scheme: Blue (N) Brown (L) YellowGreen 6 • Fasten the supply cable in place with the clamp and close the cover of the terminal board. Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. [. . . ]